Electronics Forum | Tue Sep 01 12:20:47 EDT 2009 | fujiphil
Manually load the board and activate the solenoid for table up/down. Goto I/O then check the status of the sensor. if the sensor was tripped when table is down, removed the pin and check for foreign objects. Or check the hole of the pcb, maybe the si
Electronics Forum | Fri Aug 27 10:25:52 EDT 1999 | Matthew Park
Is it feasible to have one type of board carriers to take boards thru 1) glue curing process for first side and 2)invert carriers with boards, and 3)reflowing second side, and 4) do manual stuffing of th components and 5) take them thru selective wav
Electronics Forum | Fri Jul 08 10:11:44 EDT 2005 | Luke Mittur
Hello When the table goes back to loading position, it checks for the avaialbility of the board. It is possible that there is a component right under the PCB confirm sensor and the sensor is not able to recognise the board, so it unclamps . No
Electronics Forum | Tue Sep 01 11:46:09 EDT 2009 | andoe
when the cp6 loads a board everything seems normal / as the table drops the pcb lines up onto the origan hole and then instantly fails with -- "original pin error" we have run this board before. any ideas? thanks
Electronics Forum | Thu Jun 30 05:22:11 EDT 2005 | dougs
it's been a while since i've worked on a CP6 but there is a sensor around the X-Y table ( near the back, it's not attached to the table, it sits just below the turret area )that tells the machine if there is a board there, i think you need to set thi
Electronics Forum | Wed Sep 01 13:58:10 EDT 1999 | Dave F
| Is it feasible to have one type of board carriers to take boards thru 1) glue curing process for first side and 2)invert carriers with boards, and 3)reflowing second side, and 4) do manual stuffing of th components and 5) take them thru selective w
Electronics Forum | Fri Feb 02 15:22:32 EST 2024 | carl_p
Machine a clamp into or from the FR4. to Tension the boards into place
Electronics Forum | Mon Jan 29 13:11:31 EST 2024 | erikfriesen
I'd like to build my own carriers using tg fr4 as we have in house Cnc. Where can I find flush corner clamps? Or are these typically custom manufactured by individual carrier board manufacturers?
Electronics Forum | Wed Feb 07 15:31:05 EST 2024 | proceng1
We have a few custom made fixtures that use a flat disc like that and they are spring loaded. For our "homemade" fixtures, we generally use screws stocking up in the tooling holes that are cut to only stick up approx .050 on an .062 board, so there
Electronics Forum | Fri Nov 30 05:28:12 EST 2012 | d0min0
Hello, we are starting with the flex pcb production, can anyone advice a company in europe that is capable of design and manufacture palett / carriers / frames that allow to produce flex boards in standard smt process regards
