Electronics Forum | Fri Jan 27 20:10:16 EST 2006 | peter
hi guys the scenario is: when placing parts which required maximum speed, the cp6 sometimes missing resistors here and there, when checking part data, everything ok i notice that when the machine switching between high and low transport speed, (eg: r
Electronics Forum | Tue Jan 31 02:59:18 EST 2006 | jgarver1
You also should check to make sure you have blow off at the placing station set properly. I have seen machines with the flow control valve shut completely off not release parts properly. The parts end up in the scrap bin and the machine thinks they
Electronics Forum | Sun Jan 29 11:59:13 EST 2006 | johnw
Hi Better to check the table calibration and wedges also the rack and pinion gear at the back of the table for control if you go into mechacheck you can set the servo and the calibration data if its an early cp6 its quite simple to set up if its a cp
Electronics Forum | Tue Jan 31 03:34:50 EST 2006 | chadnugent79
If you are sure that your part data is correct, have you checked the calibration of Z origin? Are the parts leaving an impression on the paste or is there no indication of an attempted place. How small of resistors are we talking 0402, 0603, 0805?
Electronics Forum | Mon Jan 30 13:26:12 EST 2006 | Tech
Another thing to keep in mind are the vacuum hoses. The early models had a real problem with the vacuum hoses that connect to the back of the windmill. They would crack or wear through due to rubbing and cause a loss of vacuum which could cause your
Electronics Forum | Tue Sep 01 05:28:49 EDT 2009 | aj
start skipping out some parts and try to transmit? could be a dodgy part data... Best thing to do is skip out everything except one part and see how you get on with the transmission and work from there. If it transmits start addin a few more until y
Electronics Forum | Wed Jun 29 19:33:12 EDT 2005 | matjen
After the machine stops for any reason when restarted the z table goes to loader position comes up then goes back down and re-reads the fiducials, only one machine does this but we are losing valuable cycle time after every part change. We have Fuji
Electronics Forum | Thu Dec 11 08:20:05 EST 2003 | liang
we ofen have the problem of the part missing.when problem take place .we found the segment sleeve is anomaly.we change the sleeve is ok!but we don't know what is wrong with the sleeve.who can help us ,thks!
Electronics Forum | Thu Dec 11 19:32:11 EST 2003 | stefwitt
Let me guess, you are talking about a Siplace S15 or F3. The bearings around the sleeve could be dirty and create too much friction for the little turning motors to rotate the sleeve. What do you mean by parts missing? Are you saying components are
Electronics Forum | Sun Dec 14 08:26:16 EST 2003 | liang
MR/MADANM STEFAN ,WE USE A PLASTIC PLUNGE.WE REPLACE THEM THREE MONTH.WHEN PART MISSED,WE CHECK THE VACUUM ,IT IS OK. IT IS ONE OR TWO SEGMENTS WHICH CAUSE PART MISSING.WE REPLACE A PLUNGER ,IT IS NOT OK.WHEN REPLACE A SLEEVE .IT IS OK.WE CHECK THE S
winsouce.jpg)
