Electronics Forum | Thu Jun 11 06:57:22 EDT 2015 | cyber_wolf
Linux, The amount of error that you are describing is about the thickness of a human hair. Unless you are placing 0201's I can't understand why .12 is an issue. There are many factors that can effect placement accuracy on a CP6 For instance: 1. M
Electronics Forum | Sun Jun 07 19:16:54 EDT 2015 | linux
Hello everyone, I'm looking for help with placement issue on our cp6 Fuji. On occasion we have to adjust co ordinates on the x and y axis usually about 0.12mm. Ball screw was replaced did not fix issue. Anything else we could try. Thanks everyone
Electronics Forum | Tue Aug 24 17:47:50 EDT 2010 | smtmax
I'm looking for CP6 fuji feeder. 16mm x 12mm (KO=8.3mm) 24mm x 20mm (KO=10.9mm) Please help! Thanks!
Electronics Forum | Fri May 30 08:24:08 EDT 2008 | cyber_wolf
The nozzles get centered at zero degrees and 180 degrees. I believe the yellow asterisk is the measurement at zero degrees, when it rotates to 180 is when you will get a red X or a green O. (In other words the yellow asterisk is normal) I think you
Electronics Forum | Thu May 29 14:57:26 EDT 2008 | rodrigo
Hi all, Is it normal for some of the small nozzles to be rejected by the wide view camera? Every time I do a nozzle centering the narrow view camera shows green circles for nozzles 1,2,3,4. The larger ones (5 and 6) show the asterisk. The wide view c
Electronics Forum | Thu Oct 04 00:01:59 EDT 2018 | gaintstar
Flason SMT FUJI Pick and Place Machine: http://www.flason-smt.com/product/FUJI-Chip-Mounter-SMT-spare-parts-A10395-Fiber-Amplifier.html http://www.flason-smt.com/product/FUJI-Chip-Mounter-SMT-spare-parts-Amplifier-A1038t.html http://www.flason-smt.co
Electronics Forum | Fri Aug 05 08:15:39 EDT 2016 | jdengler
The IP3 specs are: PCB Dimensions Max: 508 mm x 457 mm - Min: 80mm x 50mm Thickness: 0.8 to 4.0mm Component Capacity Tape: 74 - 8/12mm Device Locations Tray: 40 Locations Placing Rate: 0.55 sec/component for small chips 1.25 sec/component for ICs
Electronics Forum | Tue Mar 17 16:56:45 EDT 2009 | gregf912
Sorry Keith but is not possible to place 0201 parts on the CP43 machine. THe XY table is not tight enough on the resolution or the Z height. The parts camera will not be able to tell the part from the nozzle. THe CP6-4000 machine can not do 0201 part
Electronics Forum | Fri Dec 08 19:02:12 EST 2023 | madisreivik
Found the main problem During messing around (hopelessly :) we had found the calibration menu and pressed "check". Machine thought that there was a calibration nozzle (maybe 10x10mm square) but in reality, there was d=1.0mm nozzle. Machine decided
Electronics Forum | Sat Dec 30 19:02:19 EST 2006 | mika
This type of component packages works best with vision type: 254 - irregular. Measure the total package length including the leads. Also set the body dimension x-y tolerances to at least 0.35mm and the the pick up x-y tolerences to 0.5mm in the part
winsouce.jpg)
.gif)
