Electronics Forum | Thu Jun 11 07:26:20 EDT 2015 | linux
Think you right, not enough to be worried about. Thanks for all your help.
Electronics Forum | Thu Jun 11 03:59:00 EDT 2015 | linux
Sr Tech. Thanks for reply, We don't have the same issue with other cp6, was wondering was there anything else we could check?. Thanks again.
Electronics Forum | Wed Jun 10 10:38:51 EDT 2015 | cyber_wolf
The published Fuji CP6 placing accuracy specification is plus/minus .1mm I would say that your machine is running just fine.
Electronics Forum | Sun Jun 07 19:16:54 EDT 2015 | linux
Hello everyone, I'm looking for help with placement issue on our cp6 Fuji. On occasion we have to adjust co ordinates on the x and y axis usually about 0.12mm. Ball screw was replaced did not fix issue. Anything else we could try. Thanks everyone
Electronics Forum | Thu Jun 11 06:57:22 EDT 2015 | cyber_wolf
Linux, The amount of error that you are describing is about the thickness of a human hair. Unless you are placing 0201's I can't understand why .12 is an issue. There are many factors that can effect placement accuracy on a CP6 For instance: 1. M
Electronics Forum | Wed Apr 12 06:40:11 EDT 2006 | aj
All, I continuosly have reliability issues when placing a SOT363 device. I have Fuji CP6 and CP4 placement machines. The part data has been analysed down to the finest detail but it is still hard to maintain any consistency. Anyone else have simi
Electronics Forum | Thu Apr 13 15:55:08 EDT 2006 | FredC
I am not familiar with the sot363. Is it large enough that you could use a 4mm, 5mm, or 8mm O ring type nozzle? If it is large enough to use one of these nozzles the O ring is slightly compliant and the O ring material has a higher coefficent of fric
Electronics Forum | Thu Apr 06 14:29:11 EDT 2006 | vikkaraja
check placement XO/YO and mark read position using fuji board.
Electronics Forum | Sun Jan 29 11:54:06 EST 2006 | johnw
Hi Dax you want to run a cal card with good cad data on all machines then take the results and then alter the placement xy data to pull all machines into calibration. But make sure all the cameras are calibrated and the pam results are good and withi
Electronics Forum | Mon Jan 30 01:34:28 EST 2006 | ____
Export CCIMF files for both scenario's and have Fuji America look to see if there is an actual programming offset problem. To be exactly .3mm off seems a little odd.
