Electronics Forum | Fri Sep 18 03:02:07 EDT 2015 | linux
Hello everyone. Need urgent help with our cp6, when front door is open servo amp alarm comes up, this error will clear using the reset button. Has anyone any idea how I would go about fixing this issue.
Electronics Forum | Fri Jul 17 07:50:32 EDT 2009 | csm
Dear Jepoy We check the oilmatic system and I found a relay is not working, it will arrive until tomorrow. We still have 2 errors and 1 message, we are taking time because we don't have the Fuji CP6-4000 manuals or electric diagrams. we get this ma
Electronics Forum | Fri Jul 17 19:43:20 EDT 2009 | fujiphil
Have you eliminated the hardware N.G.? Check the connection for the rear door. If the connection are ok, try to bypass the key. short the two wires for the rear door. If the rear door problem is corrected, check the rear door switch physically. Reg
Electronics Forum | Wed Jul 12 17:05:22 EDT 2017 | rodrigo
Hi all, Our Fuji cp6 woke up with a bad power supply (ps) this morning. The ps is one of two 24vdc (Corsel P300E-24). There is one inside the cabinet and one on the door where the cpu card is. The bad one is the one inside the cabinet. So we had anot
Electronics Forum | Tue Nov 06 07:37:02 EST 2007 | cyber_wolf
Does anyone out there have a method of cleaning CP6 shaft clutches that is "easier" ? I am not a fan of just pulling the shaft down and wiping it out. I like to take them apart and clean/lube them. It is a pain to get the crowns back on without rip
Electronics Forum | Thu Aug 29 05:01:38 EDT 2013 | bobpan
Motor Error 5 is usually an interlock error. Take off the rear right cover and look at the red and green led's on the driver cards. If they are both lit....you have a door open or if you have carts....a feeder base switch is up. Good Luck
Electronics Forum | Mon Aug 22 09:48:35 EDT 2005 | PWH
Post a simple CAD picture of a BGA or IC on the door of the machine near where it gets loaded. This has helped us. Flash IC's can also be difficult as you can't always put pin one near front, left of tray slot. So... we always say pin one left no
Electronics Forum | Wed Sep 27 17:49:41 EDT 2006 | SWAG
Open the rear door that has the cooling fans on it. Look at the wiper blade regulator, look toward the front of the machine about 8" or so and to then left 3"or 4". There should be a lexan cover/box over the board that has this pot. on it. If stil
Electronics Forum | Sat Oct 21 19:25:42 EDT 2006 | Ola
I assuming that you already have checked the fuses? Also, check all the power: +5V, +12V, +-24V, etc. We had to change our PSU once, after a major power-drop due to a thunderstorm. But you should be ok if you can pinpoint what type of voltage you are
Electronics Forum | Mon May 06 14:55:58 EDT 2013 | dyoungquist
We had that problem on our M12. There were a few components that had gotten dropped into the camera area as the hydra head past over it. Our MY12 has a knob towards the front of the machine in direct line with the camera. Pulling this knob release
