Electronics Forum | Fri Sep 18 03:02:07 EDT 2015 | linux
Hello everyone. Need urgent help with our cp6, when front door is open servo amp alarm comes up, this error will clear using the reset button. Has anyone any idea how I would go about fixing this issue.
Electronics Forum | Sun Jan 29 11:59:13 EST 2006 | johnw
Hi Better to check the table calibration and wedges also the rack and pinion gear at the back of the table for control if you go into mechacheck you can set the servo and the calibration data if its an early cp6 its quite simple to set up if its a cp
Electronics Forum | Tue Jul 12 03:57:55 EDT 2005 | woodglass
Hi, In the CP6 propers, there are values: PCB Check Position X, & PCB Check Position Y. These are the servo counts that the X/Y table moves to when checking if a PCB exists on the table. Your sensor does not detect a PCB, probably because when checki
Electronics Forum | Mon Jun 19 13:53:18 EDT 2006 | choppy
Does it reach the home sensor ? Is it activated ?
Electronics Forum | Tue Apr 04 22:19:28 EDT 2000 | Hermie
One of our Servo Amp that controls the X table motor drive went bad and was replaced with a new one. I want to play around with the one that went bad and see if I can fix it. What I need is someone to help me who had experienced with fixing the servo
Electronics Forum | Mon Jun 19 10:10:18 EDT 2006 | rmitchell
Hi, Our CP6-5 has a Z overflow error when trying to zero set. The table moves in X and Y and almost zeros prior to the Z overflow. Servo Amp? Rob
Electronics Forum | Wed Jun 21 09:23:28 EDT 2006 | rmitchell
problem solved. Some PCB table support pins were jammed down in the table preventing the Z axis from lowering all the way. The intial error mesage was x and y servo, but the real error was the z axis overflow. Rob
Electronics Forum | Wed Jun 21 04:11:31 EDT 2006 | daxman
Are you familar with using the mecca mode on Fuji machines? There is a procedure I can take you through that will check the servo amp and allow you to adjust it. Is your machine useable at all? can you get it to pass zero set? If you can, view your s
Electronics Forum | Tue Apr 04 23:01:37 EDT 2000 | Dean
Does Fuji America have a trade in program? I know they used to on vision cards and such. It may be worth your while to get a trade in allowance rather than none at all. The alternative, as you mentioned, is to repair it yourself. This however, w
Electronics Forum | Thu Jul 06 19:41:31 EDT 2000 | Hermie
We recently installed a new Servo-Amp which controls the X-Y table on our CP6 machine. Eversince, we are experiencing a Cycle alarm X-reach on the machine. We tried to greased the table a little bit more but the only thing that seems to work is to sl
winsouce.jpg)
.gif)