Electronics Forum | Tue Jul 12 03:57:55 EDT 2005 | woodglass
Hi, In the CP6 propers, there are values: PCB Check Position X, & PCB Check Position Y. These are the servo counts that the X/Y table moves to when checking if a PCB exists on the table. Your sensor does not detect a PCB, probably because when checki
Electronics Forum | Tue Sep 01 11:46:09 EDT 2009 | andoe
when the cp6 loads a board everything seems normal / as the table drops the pcb lines up onto the origan hole and then instantly fails with -- "original pin error" we have run this board before. any ideas? thanks
Electronics Forum | Thu Jun 11 06:57:22 EDT 2015 | cyber_wolf
Linux, The amount of error that you are describing is about the thickness of a human hair. Unless you are placing 0201's I can't understand why .12 is an issue. There are many factors that can effect placement accuracy on a CP6 For instance: 1. M
Electronics Forum | Fri Apr 23 02:15:36 EDT 2010 | smellew
Hi Rodrigo, Have you fixed your CP65? do you need some help? llew
Electronics Forum | Fri Apr 16 17:44:40 EDT 2010 | rodrigo
We're still trying to fix a C-axis overflow error in our CP-65. I was swapping servo boards and one of them started to blinks a 2 on the LED single digit display and the machine didn't boot up. I replaced the servo board with a spare we bought on eba
Electronics Forum | Fri Jan 15 14:32:12 EST 2021 | marcelorotofrance
Hey there We have a second hand (or third or fourth...) Contact 3Z-100 non functioning, received as is. I am in the process to asses its condition and try to get a diagnosis. After DOS boot, 3Z.EXE executes and in the screen it reads: "Initi
Electronics Forum | Sat Jan 29 12:01:32 EST 2011 | jts142
hi i am having problems with a cp 643 when i run in auto it errors unloading a board with the x axis servo interlock error but if i hit sequence end stop so that it stops after every board it runs and unloads perfectly. Any hints or suggestions we ha
Electronics Forum | Tue Feb 01 13:21:34 EST 2011 | cyber_wolf
Try switching to a different board and see if the error goes away. If it does, it has something to do with one of the loader sensors not being made.
Electronics Forum | Wed Jun 25 18:19:49 EDT 2014 | guts1872
During machine run, sometimes when we stop to change parts the servos wont start back up. There is a message on the screen that says "Amplifier is resetting power". When that message clears and push the servo on button nothing happens. There is an er
Electronics Forum | Tue Jul 08 15:34:21 EDT 2014 | guts1872
Unfortunately it seems we have a worse problem than a Z rod spring. The machine was running fine this morning but ran out of a part, and when I shut the door and pressed Servo On nothing happens again. I shut down and let sit for a while. Now I get a
