Electronics Forum | Mon Oct 19 14:24:09 EDT 1998 | Robert Cass
Desperately seeking station 13 belt for Fuji CP6
Electronics Forum | Tue Jan 31 02:59:18 EST 2006 | jgarver1
You also should check to make sure you have blow off at the placing station set properly. I have seen machines with the flow control valve shut completely off not release parts properly. The parts end up in the scrap bin and the machine thinks they
Electronics Forum | Sun Jan 29 11:59:13 EST 2006 | johnw
Hi Better to check the table calibration and wedges also the rack and pinion gear at the back of the table for control if you go into mechacheck you can set the servo and the calibration data if its an early cp6 its quite simple to set up if its a cp
Electronics Forum | Mon Jan 30 13:26:12 EST 2006 | Tech
Another thing to keep in mind are the vacuum hoses. The early models had a real problem with the vacuum hoses that connect to the back of the windmill. They would crack or wear through due to rubbing and cause a loss of vacuum which could cause your
Electronics Forum | Wed Mar 10 13:04:10 EST 2004 | jpa
I need to purchase a rework tool mainly for QFP's including 30mm x 30mm. I was looking at a Metcal QX2 and a Pace TF200. I would welcome any comments on these two products or any other suggestions. Also, is a preheater necessary?
Electronics Forum | Tue Jul 14 13:13:35 EDT 2015 | goodting
Not found, any recommendation?
Electronics Forum | Fri Jul 10 13:46:18 EDT 2015 | goodting
That is the good site to looking for... Thx
Electronics Forum | Tue Jan 13 10:51:42 EST 1998 | FINETECH GmbH
Please have a look at our homepage below http://aol.com.members.com/finetecger/ and than contact us via email.
Electronics Forum | Thu Nov 17 13:51:27 EST 2005 | mnguyen
Never could get that thing to work rite. Better off getting a glue stencil or a manual dispenser. Even if you do get it to work it is difficult to control the glue dot size to stay stable either you get too much or not enough.
Electronics Forum | Mon Mar 31 13:51:33 EDT 2008 | gregorys
Hi! May be somebody help me with links to materials or document`s for assign separate (separate room) installation of cleaning equipment from all another SMT line. p.s. some managers of my company want to install solvent based cleaning units in same
