Electronics Forum | Tue Jan 29 14:30:38 EST 2019 | younes
CP642 WORK in WHETH NO ERROR in ONE PROGRAME.IF I CHANGE IT ERROR STATION 19
Electronics Forum | Sun Jul 11 21:10:27 EDT 2010 | fujiphil
First, check the sensors for 17th and 19th station....tune the sensor amplifier if necessary. Then, check the dogs on the nozzle holders... If the above, items are ok... check the 13th station clutch engagement. Calibrate if necessary... fujiphil
Electronics Forum | Fri Jul 09 23:45:22 EDT 2010 | dman97
I have a CP642 machine that always gives me a Station 17 or Station 19 nozzle error when the machine selects the 2.5mm 3.7mm or 5.0mm nozzles. It always throws an unknown nozzle station 17 error after all the heads have switched to the above mention
Electronics Forum | Thu Jun 24 07:22:19 EDT 2004 | cyber_wolf
I know I have posed this question before, but I would like to open this discussion again. We do several change overs through the course of three shifts on our CP642 line. When we start a new job, we have tons of tape feeder overlay problems.(The over
| 1 |
winsouce.jpg)
.gif)
