Electronics Forum | Mon Jul 28 18:31:43 EDT 2003 | mantis
Hi There, First has the machine in question had the camera upgraded to accomdate 0603/0402. It sounds like there is a bad pickup on this part.Are all nozzles ok is feeder indexing correctly has part pick up position(Station 1) been calibrated. Hope t
Electronics Forum | Wed Aug 06 14:52:15 EDT 2003 | cyber_wolf
Checking the vacuum at all stations is a good place to start. A vacuum guage with a piece of hose attached to a CP nozzle is a very handy tool to have. If you notice less vacuum at any one of the stations, you can start by looking @ the spool valves
Electronics Forum | Fri Mar 13 15:00:18 EDT 2009 | dman97
Can somebody take a look at this screen shot and tell me what it is supposed to mean. Every time I try to transmit this program to my CP642 machine I get this error. Does any one know what this error means and how would I correct it? Thanks for yo
Electronics Forum | Sat Dec 01 18:08:03 EST 2007 | jmelson
Hello, I just ran into a crazy problem with my CSM84. I did a batch of one side of a board, then loaded the program to do the top side, and it stops with the head over the 3rd component's feeder, and reports error 117:overflow. The maintenance manua
Electronics Forum | Tue Jan 29 14:30:38 EST 2019 | younes
CP642 WORK in WHETH NO ERROR in ONE PROGRAME.IF I CHANGE IT ERROR STATION 19
Electronics Forum | Fri Jul 09 23:45:22 EDT 2010 | dman97
I have a CP642 machine that always gives me a Station 17 or Station 19 nozzle error when the machine selects the 2.5mm 3.7mm or 5.0mm nozzles. It always throws an unknown nozzle station 17 error after all the heads have switched to the above mention
Electronics Forum | Thu Mar 22 17:18:17 EDT 2018 | rodrigo
Hi all, Our (new/used) CP642 resets the nozzles heads first time I do a nozzle centering after power on. But we're getting errors st17 and st19 and while working on the sensors I noticed that it does not resets the heads before I start a nozzle cent
Electronics Forum | Tue May 05 14:57:48 EDT 2020 | greezmky
I will have to check the nozzles to see if they are stuck up, but I don't believe so as I changed them all out a couple weeks ago. I have not went back to the feeder yet because I am not getting vision errors. I was able to see the diodes fly off on
Electronics Forum | Wed Jan 18 12:57:22 EST 2006 | cyber_wolf
Since I have posted on this last, we have found that 99% of our nozzle sticking problems are do to part height problems. I have been told that CP6 machines are very sensitive to part height do to the amount of spring travel in the nozzle. If you hav
Electronics Forum | Thu Nov 18 14:38:59 EST 2004 | EED
There is a couple of things to check. Put the machine in diagnostics and let the chain run. You should see it run the same as you would if purging it. Sometimes the 2 hall effects at the disk do not see the disk as it turns. Check the driver board
.gif)
winsouce.jpg)
