Electronics Forum | Fri Dec 19 17:11:24 EST 2014 | guts1872
My QSP2 motors keep shutting off with an error message on the screen that says Z1 motion fail. Z safe motion motion failed due to previous error. When homing the heads I observe the servo amp indicator LEDs. They are all green while the gantries are
Electronics Forum | Mon Dec 22 04:55:41 EST 2014 | bobpan
Swap the amps but first manually check by hand to make sure the z-axis is free to move up and down. Sometimes a part can get stuck in the gears. Good Luck
Electronics Forum | Fri Sep 18 03:02:07 EDT 2015 | linux
Hello everyone. Need urgent help with our cp6, when front door is open servo amp alarm comes up, this error will clear using the reset button. Has anyone any idea how I would go about fixing this issue.
Electronics Forum | Mon Jan 31 13:02:43 EST 2005 | jgarver1
Do you have an extra VME Servo Board to try? Servo Overflows are not as common as Over Currents or hard amplifier failures. They seem to be resolved by replacing the servo board and not the amp or motor. My $.02
Electronics Forum | Thu Jan 20 06:38:27 EST 2005 | unknown
Please contact NMTronics, they can give you some decent advice
Electronics Forum | Sun Jan 30 10:50:21 EST 2005 | jimmyb
Is it still happening, or did you already solve it?
Electronics Forum | Fri Feb 04 06:15:21 EST 2005 | deepak
thanks for the suggestions. will e-mail the details to you.
Electronics Forum | Thu Jan 20 06:01:23 EST 2005 | mhe
Hi guys, we are facing a problem - d axis servo overflow in our fuji cp-4. Can anyone please suggest some remedy? thanks deepak
Electronics Forum | Tue Feb 01 14:26:53 EST 2005 | johnw
Just for starters you are experiencing a possible closedloop feedback error 1 your motor is on its way out 2 increase the reach pulse in propers 3 check gain of servo mail me for more info
