Electronics Forum | Tue Jun 11 14:16:03 EDT 2013 | bandjwet
We are involved in a project for microBGA SAC rework. The pitch is 0.4mm and the devices are underfilled (softening 150C). The underfill comes off fairly easily but the pressure underneath the package as the underfill softens pushes up on the undersi
Electronics Forum | Tue Jun 11 14:21:35 EDT 2013 | bandjwet
We are involved in a project for microBGA SAC rework. The pitch is 0.4mm and the devices are underfilled (softening 150C). The underfill comes off fairly easily but the pressure underneath the package as the underfill softens pushes up on the undersi
Electronics Forum | Wed Nov 08 05:19:28 EST 2006 | amigo
It's not underfill is it? Sorry, but i don't know what is underfill, if you mean BGA, yes it is BGA !also sorry for very very late reply
Electronics Forum | Mon Sep 28 09:23:03 EDT 2015 | slave2anubis
Hi, sorry for reopening a old thread, but i wanted to ask if there is a way to know at what temperature the solder melts if you have a chip with underfill? I thnk its lower then normal air-fill temperature since the underfill conducts heat better the
Electronics Forum | Mon Jun 06 07:14:21 EDT 2005 | pci
We find it impossible to remove the glued chips > like the CPU and the UEm ICs in Nokia Mobile > Phones. They are both surface mount devices and > glued with some chemicals we think. Any help is > most needed in this matter. May we know what pr
Electronics Forum | Mon Jun 06 04:36:44 EDT 2005 | rlackey
It's not underfill is it?
Electronics Forum | Fri Mar 28 10:11:31 EDT 2014 | davef
hege: beer can opener!!! The ultimate multipurpose tool ... BR davef
Electronics Forum | Fri Mar 28 16:27:43 EDT 2014 | hegemon
Lol Dave. Give me a lever long enough....
Electronics Forum | Sun Jun 05 13:42:16 EDT 2005 | amigo
We find it impossible to remove the glued micro-BGA chips like the CPU and the UEM ICs used in Mobile Phones. They are both surface mount devices and glued with some chemicals we think. Any help is most needed in this matter.
Electronics Forum | Tue May 19 08:20:10 EDT 2009 | Mity C
Good Morning, We are underfilling some of our BGA's. This is a specified customer requirement. The material we are using is Emerson & Cuming E-1216 (also specified by the customer) The material was selected because of a close CTE match with the PCB.