Electronics Forum | Fri Jan 15 13:35:03 EST 1999 | Terry Burnette
| I saw the problem of void in solder bump or in lead less component or some BGA. But I didn't have standard specification of that void is accept or reject? Do any body have the better idea or suggestion of the criteria ? | | Thank you, | Wirat
Electronics Forum | Thu Dec 09 07:46:42 EST 2004 | davef
We did this for BGA pads, but have not thought about other types. So, this may or may not apply for those. Pad defined by:||Advantages||Disadvantages Non-solder mask||No point-of-stress concentration at edge mask and solder ball||Smaller pads have
Electronics Forum | Fri Aug 06 10:27:05 EDT 1999 | Kenneth Hedman
| | I saw the problem of void in solder bump or in lead less component or some BGA. But I didn't have standard specification of that void is accept or reject? Do any body have the better idea or suggestion of the criteria ? | | | | Thank you, |
Electronics Forum | Wed Sep 13 12:08:02 EDT 2000 | Dave F
Charlie: I'm with Wolfgang ... The prime cause of your cracked solder joint on a surface mount part is mechanical stress. That�s about as specific as you�re gonna get. More information would be helpful. For instance: * Talk about the distribution
Electronics Forum | Wed Sep 13 12:01:26 EDT 2000 | Wolfgang Busko
Hi Charly, short question, short answer: excessive mechanical influence often in combination with bad solderjoint itself. For bad solderjoints there are many many reasons, process and material related. Are there any special circumstances that made y
Electronics Forum | Mon Oct 29 18:21:43 EST 2001 | slthomas
We recently have received a lot of warped (bowed and/or twisted behond IPC 600 specs.) bare boards (some our fabricator's fault, some ours by design) and I can't help but figure that long term reliability will suffer when building product with them.
Electronics Forum | Tue Oct 30 10:54:37 EST 2001 | slthomas
Hey, Preacher, choir here. Unfortunately I didn't get to make the call here (hot boards, new product, same ol' same ol'), but I dam* well am looking for future (print) backup to assist in persuading the bottom line guys that it's cheaper to wait for
Electronics Forum | Mon Oct 29 20:19:44 EST 2001 | davef
DON'T do it!!! The two problems you'll have are: 1 Poor manufacturing process control, resulting in weak solder connections. 2 Weak solder connections are stressed, when the board is straightened upon installation in the "box". There's several hits
Electronics Forum | Wed Jul 10 22:32:46 EDT 2002 | redmary
i just find the gap inside the component from the cross-section, it indeed exists the interal crack, not solder joint crack. but why the failed capacitor is well after some time. and the other suspicion is the quality of the component.
Electronics Forum | Thu Jul 10 11:49:26 EDT 2003 | davef
Dang!!!! ;P Hey, wait a minute!!! The BIG DOGS believe "it's a service, not a problem". Are you saying that they think that you're fortunate to get parts falling off of the boards? So there cracks are part of the value added? Whee!!