Electronics Forum | Fri May 29 08:25:13 EDT 2009 | floydf
We are getting what looks like cold solder joints on one of our boards. The boards have an aluminum substrate, and use OSP plating. The solder is lead free - 96.5 Sn, 3.0 Ag, .5 Cu. The flux is no clean. When we first had the problem, my solder profi
Electronics Forum | Fri May 29 23:11:08 EDT 2009 | isd_jwendell
Have you tried different board orientation through the oven, or have the boards been put through the same way each time?
Electronics Forum | Mon Jun 01 17:49:39 EDT 2009 | gregoryyork
Sorry looking at your profile again and considering its Aluminium substrate I would opt for an increase to the preheat or introduce a soak to the profile to get the PCB up to reflow. Try soaking between 175 - 200C sufficient enough to heat the whole
Electronics Forum | Thu Jun 04 14:35:11 EDT 2009 | floydf
We wound up using a ramp to spike profile with 50 sec. between 150C and 217C and 90 sec. above 217C. The idea being the flux is still active when it hits reflow, and it stays in reflow long enough for the weird alloy in the parts lead to wet. All par
Electronics Forum | Fri May 14 00:28:09 EDT 1999 | Mike D.
| I am seeing reflow around my signal pins after being subjected | to a profile of 204c for 1 minute and 225c for a min of 30 seconds. Signal pins are soldered into a copper plated alum. case with SB5 and then silver plated. The pins have a hot oil
Electronics Forum | Mon Jun 01 17:41:20 EDT 2009 | gregoryyork
What is your squeegee pressure and size. Also does the pad sit on a ground plane, as it looks like it is partially reflowed so surface has gone but not coallesced properly which would indicate it is more a problem with reflow above 217-219C OR obviou
Electronics Forum | Mon Jul 15 08:11:04 EDT 2013 | emeto
I am pretty sure that is a moisture issue. You should probably bake your boards and some of your parts.
Electronics Forum | Thu Jul 18 04:42:32 EDT 2013 | ericrr
Thanks for that, sorry Im late setting (set by someone else) Speedline Bravo Top 1st chamber, 2nd, 3rd, 4th. 170° (c), 180°, 190°, 270°. Bottom 170°, 180°, 180°, 260° chain speed 27cm/second.
Electronics Forum | Tue May 25 07:03:34 EDT 1999 | Milan Z.
After reflow proces in convection-IR oven we find broken body of SOT23 elements. There is no problems on other elements (SOIC, chip R,chip C, etc) Where is the problem? Thanks in advance!
Electronics Forum | Wed Oct 03 17:07:52 EDT 2001 | davef
We have had soldering problems with fine pitch QFP in the past [and probably will in the future]. Several questions leap to mind: * When you took your profile on the component pads, do you profile on the pads that did not solder well? * When you say
