Electronics Forum | Tue Jul 09 15:55:36 EDT 2019 | alpha1
Have you checked the bearing on the linear slide bearing on the CTA?
Electronics Forum | Mon Jul 08 18:45:53 EDT 2019 | assuredtech
Would you happen to have the Jig used to check that the component itself is in spec with UIC's general specifications? 1.) Component in spec. 2.) Correct 2.5mm pusher on the feeder / dispense head. Also set the conditioner guide where the comp enter
Electronics Forum | Mon Jul 08 12:21:17 EDT 2019 | slthomas
I forget which type of CTA that machine has so I probably won't be much help. It's been ages since I worked on them but it doesn't look like you'll find many people that have. That said, usually if you get things aligned properly and it still bends
Electronics Forum | Tue Jul 02 15:20:16 EDT 2019 | daniel_marquette
Hi, any idea what can cause 5% intermittent right component lead being bent during CTA transfer to the forks? Yet, everything is line up on these 2.5 mm lead span components.
Electronics Forum | Tue Nov 11 08:08:43 EST 2003 | Chris
Use a Radial lead inserter. you will need 1 head for each different part number you have. the machine cannsert 2.5 $ 5.o mm lead components and 7.5 with special to0ling. For LED you want to use a Radial with the new dual spocket CTA (Component transf
Electronics Forum | Tue Jul 09 15:40:06 EDT 2019 | assuredtech
That's a great point about air consumption, don't reduce the 1/2 inch air line requirement, meet the CFM air requirement and of course dry shop air. Check the Auto oiler for the CTA is running correctly, 5W 30 NON Detergent oil only. Attached is a pi
Electronics Forum | Mon Jul 08 16:03:06 EDT 2019 | slthomas
My recollection is that there is a carrier clip locator that positions (centers) the clip in front of the CTA. Has the adjustment on that been confirmed as well? (Edited because some of it's coming back to me!): I think there is a diamond shaped pin
| 1 |
