Electronics Forum | Fri Feb 11 08:28:21 EST 2005 | jdengler
Simple answer no. Do the operators currently use set count and set sequence commands? How many mistakes do they make with just these 2 commands? Then in a few years you will find your operators have turned over again and you will have less knowl
Electronics Forum | Thu May 30 13:43:07 EDT 2013 | gnus
directory. Once at C:AP> type in "type password.bin" this will display what the current passwords are set to. If that doesn't work try using that command at the C:> directory. Write down what the passwords are currently set to, DO NOT attempt to ch
Electronics Forum | Thu Aug 30 11:11:43 EDT 2007 | slthomas
I think you can reach that screen with SH SET command, then do a SET [command name] [value] to change it. Make sure you write down the original values somewhere or do a print screen of your current settings before tweaking them, though.
Electronics Forum | Fri Feb 18 09:35:10 EST 2000 | JohnW
Ok folk's so it's staw poll time...How are you storing you squeegee baldes? I've been asked / told / commanded to look at how we're storing our DEK and MPM Squeegee blades and improve it. Currently they are held in a cabinate matrix with the blades p
Electronics Forum | Fri Feb 18 09:35:10 EST 2000 | JohnW
Ok folk's so it's staw poll time...How are you storing you squeegee baldes? I've been asked / told / commanded to look at how we're storing our DEK and MPM Squeegee blades and improve it. Currently they are held in a cabinate matrix with the blades p
Electronics Forum | Fri Feb 11 08:00:36 EST 2005 | primus
Actually, I have never had the opportunity to discuss this with UIC. In fact, our Maintenance Engineer has told me that, according to UIC, the Set Command Variables should never be altered from their default settings except by qualified personel, and
Electronics Forum | Mon Apr 08 15:39:10 EDT 2024 | mistrthou
The error is: MOT-Command/205: Motor speed out of control Motor speed deviates from expected speed. – Problem with power supply, motor current too low. – Mechanical problem, friction too high or tool stuck in Z. I'd be looking at excessive friction
Electronics Forum | Fri Apr 26 08:20:51 EDT 2024 | radek
Hello, We recently acquired a used Viscom S6056 DS1W machine which is currently not operational. The initialization fails and we are encountering a repeated error: "D0, Vtrans command invalid." This error is also appearing with codes D4, D5, and D6.
Electronics Forum | Wed Feb 16 07:51:48 EST 2005 | primus
I would agree with you there, but I am only a shift supervisor. I am do not actually work in the maintenance department, although I do perform many repairs to the machines. So I've learned quite a bit on my own, and it was only recently that I was sh
Electronics Forum | Tue Aug 31 07:51:28 EDT 2004 | dennispoquiz
I used to do optimization on Panasert MV2F/V,Fuji CP6/4,GSM (Universal),Sanyo TCM 3000 with no problem. My problem now is on my old Sanyo V822 SMT chipshooter. I am working on a multi-block (multi-cavity) PCB panel and i cannot, in any way, mount all
winsouce.jpg)
