Electronics Forum | Thu May 20 10:01:23 EDT 2010 | jmw
Just a slight correction....the quad align card is located at the back rear right of the machine (in a cage). If it is a cyber-optics 4c machine....the laser align card is in the front card rack to the far left.
Electronics Forum | Wed Nov 27 18:10:41 EST 2002 | andrewbrook
Quad4C's have their moments. If the price is right and you are aware of the machines limitations then you will be satisfied. The placement rate is slow, 1.2 seconds/chip. Don't buy any Quad if it has the CyberOptics Laser unit, the Quadalign unit is
Electronics Forum | Tue Nov 01 13:57:18 EST 2005 | bobpan
2c belt driven.....'a little' less accurate (costs less) 4c ball screw......'a little' more accurate (costs more) vu4-vu6 upward camera for fine pitch.....cant remember but the differenc is the field of view for camera. part centering is quad-align
Electronics Forum | Tue Apr 14 15:01:00 EDT 2009 | mki
Thank you RLM, bobpan, Laser (CyberOptics) was dirty! Now is all OK. You are talking about Quad-Align. I have a lot of QUAD manuals and I still do not understand the diference among QuadAlign, CyberOptics LA and L3 LA! Please, if you can give me s
Electronics Forum | Mon Dec 12 08:05:11 EST 2005 | bobpan
Quad Align.....Cyber-optics....no difference...they both work well. Never tried a micro-bga but i know the upward camera does standard bga parts.
Electronics Forum | Wed Mar 25 18:29:47 EDT 2009 | badnewz
My Quad IVc's will also do the same thing. Mine are equipped with CyberOptics scanners, not QuadAlign. The Cyberoptics scanners do go bad and once they do, they get very warm to the touch and at the same time, if the Quad is reset, the theta axis wil
Electronics Forum | Fri Jan 03 15:16:54 EST 2014 | ppminc
If all of the lights are on, on the operator interface panel usually that means the EPCU is defective or not fully seated correctly. If you swapped out the EPCU board from another machine you need to make sure its the same type of machine. If it has
Electronics Forum | Wed Jun 07 04:48:35 EDT 2017 | dentata911
Hello Is it possible to disable CyberOptics align system. Not for single pickUp. Disable and disassemble from machine. Thank you.
Electronics Forum | Fri May 06 09:33:22 EDT 2011 | jimlas53
RLM, you have been very helpful! Let me try this on you: We have two IVC's, one with a conveyor and Quadalign, the other with a workholder platform and Cyber-optic. I just ran the first successful assembly on this second system, but the extents had
Electronics Forum | Wed Sep 04 13:58:36 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the response. 1. Function 30 gives me a consistent 182-185, even after nozzle changes. I can vary this by changing mod code 15 and I have been advised to aim for 90-110, but it doesn't seem to make any difference so I've go
