Electronics Forum | Thu May 26 15:13:47 EDT 2016 | bobpan
If there is dust (on the glass) off from the center of the lens it will add it to the part when scanning it and place off. I have ran into this twice.....I fixed it once by breaking the lens on the quad align and blowing it out.....another time I hel
Electronics Forum | Thu May 26 15:16:28 EDT 2016 | bobpan
oh ya....i forgot....to verify this....turn off all the extents for the parts and just pick them and place them....if they are very close to where they should be then it is the quad align causing the problem....this is how you can verify it. Copy the
Electronics Forum | Thu May 26 17:45:36 EDT 2016 | stevedc
Thanks for the thoughts. I will try a few things tonight so see if I can clean anything from the windows. As always, thanks for your thoughts and time :) BR, Steve
Electronics Forum | Fri May 27 09:27:56 EDT 2016 | bobpan
Glad I can help....if you have any other questions...go to my web page @ www.precision-repairs.com Bob
Electronics Forum | Fri May 27 00:18:15 EDT 2016 | stevedc
Soooo.... I started to take the laser off last night to clean it and decided to put it back on to do some more measurements to see if anything obvious turned up and lo and behold it is not good !!! Most likely cause I can think is that you were righ
Electronics Forum | Wed May 25 22:32:28 EDT 2016 | stevedc
So, I haven't used my Quad 4C for a while and when I started everything back up to run a new board it appears that the Quad align is in need of calibration. When I pick up a component and do an LAE measurement on it it shows the part center location
Electronics Forum | Thu May 26 14:06:03 EDT 2016 | stevedc
I did clean both lenses from the outside and checked all the MOD codes. I even removed the battery to reset everything and re-programmed all the codes but to no avail. I will strip it down and fully clean it to see if that helps. Just strange that
Electronics Forum | Fri Aug 07 13:03:53 EDT 2020 | assuredtech
SMT Forum, Does anyone know if the Sanyo laser alignments can be replaced with the Cyberoptics brand? If so is it plug and play or does it require any software or machine configuration changes. Thanks in advance
Electronics Forum | Mon Oct 01 05:33:15 EDT 2012 | bobpan
wow....nice job....now go get some boards ran...haha!!!
Electronics Forum | Tue Sep 25 13:33:02 EDT 2012 | bobpan
I dont think you are going to find schematics for that board. Looking through my old stuff....i dont have it and i dont recall it being in the schematics. Maybe someone else can get you a set of schematics though. Good Luck
