Electronics Forum | Thu Sep 24 07:25:34 EDT 2015 | anilwagh
I have Cyberoptics SPI SE300 Ultra machine purchased from auction. I need service/Electrical/Program manuals.
Electronics Forum | Tue Oct 13 22:56:22 EDT 2009 | cpcompany
Can anyone help me recommend or simulate a SPI > and AOI machine that can balance our FUJI NXT 1 > with 14 modules. We are using MPM accela printer. > 200 UPH is our target. > > Here's the PCB > dimension > > length(x) = 399.92mm width(y) = >
Electronics Forum | Mon Oct 12 05:54:10 EDT 2015 | anilwagh
I have brought SE300 Ultra spi machine. Is it possible to crate new program on machine? or need offline software.
Electronics Forum | Fri Jun 13 10:51:16 EDT 2008 | pforister
Pete, Thanks for the reply. I'll take a look at the 200 SE...
Electronics Forum | Tue Oct 03 17:44:23 EDT 2006 | SWAG
I am trying to get a CyberOptics SE200 on line. Does anybody have any idea why the SMEMA interface is always telling the downstream machine that a board is available? It will not switch off no matter what running condition the machine is in - even
Electronics Forum | Mon Jul 29 09:24:30 EDT 2002 | pjc
Its nearly impossibile to get any Gage R&R on systems that require the operator to posisition the board to be measured. For this you need an automatic measurement system. There are many vendors out there in addition to CyberOptics, models SE 200 and
Electronics Forum | Tue Oct 20 16:38:31 EDT 2015 | stevea
If you do not have GC Place or EPM programming software, you will be required to purchase prior to running. You can create a manual script, but very difficult and time consuming. ASC International can assist with servicing these older machines.
Electronics Forum | Fri Jun 13 10:35:30 EDT 2008 | pjc
Its a bit of an old beast, it was replaced by SE 200 and is now discontinued (since 2004 I believe). Its a decent unit, but hard to achieve good repeatability on smaller deposits. Its also not reliable on small solderpaste below 20mil fine-pitch. Fai
Electronics Forum | Fri Jan 12 19:36:36 EST 2001 | Brian W.
Cyberoptics makes a device called a Cybersentry. wonderful machine. Will work in line or off line. I used one in a former company. You program what pads and locations you want, and it can measure volume or height, and give you charts. You can en
winsouce.jpg)
