Electronics Forum | Sat Oct 22 06:49:55 EDT 2005 | moonshine
Visit http:www.moonmanondarkside.com for many free downloads including those for Lean Manufacturing. Enjoy, MoonMan
Electronics Forum | Sat Oct 22 13:11:12 EDT 2005 | mafc65
Hi, for capacity analisys I reduce a 15% of total capacity. This 15 % if for model changes,maintenance and material supply.So far no problem, I think 15 % is enough.
Electronics Forum | Wed Nov 16 09:32:46 EST 2005 | bobpan
If its newer equipment.....and newer software.....usually the software for the smt machine will tell you the estimated time once the board has been programmed. If its older equipment.....get the old stop watch out.
Electronics Forum | Wed Mar 15 10:52:27 EST 2006 | John
168 hour cycle time typical. The customer does not care if the door is opened to load more cards etc. The cards are 6x8 typical.
Electronics Forum | Thu Nov 30 07:43:36 EST 2006 | non guru
Absolutely, you should be held accountable for untrained operators, slow operators, bathroom breaks and any other human intervention! Are weekends affecting cycle time as well? You have a "tough" customer you're dealing with. Good luc
Electronics Forum | Tue Mar 20 14:34:45 EDT 2007 | realchunks
Hi Bill, Gasketing between the board and stencil may leak alittle, giving you a fuzzy print. If not, you should be OK. Another variable may be you need to perform an understencil wipe more often, adding to your cycle time. So why ya wanna double
Electronics Forum | Tue Apr 17 00:21:49 EDT 2007 | pfifla1
I am personally a fan of the ape sniper systems. seems like they have good cycle times and repeatability.
Electronics Forum | Thu May 24 17:11:22 EDT 2007 | colormaker
Everthing is the same. I did not check water temp or wash cycle time. No DI just straight from water supply. How do I do the DI ? Jerry
Electronics Forum | Thu Mar 27 16:14:24 EDT 2008 | mikesewell
If you get into a discussion with a Lean guy/gal, takt will be the rate of customer demand. People often use takt & cycle time synonymously...FWIW
Electronics Forum | Tue Jun 02 21:13:08 EDT 2009 | kircchoffs
thanks for the inputs. we are planning to run on fuji nxt i think cycle time will not be an issue. i still have another question if we can still use the same reflow profile for paste? or do we need to create another profile?