Electronics Forum | Wed Jan 31 13:00:43 EST 2007 | bvdb
The continuing saga - we got the IP-1 communicating with the MCS16 again by replacing a couple of chips on the VME1152 CPU board and now it's working again but have a new problem. The machine stops about every other time when changing nozzles with a
Electronics Forum | Thu Jun 13 20:03:05 EDT 2019 | dekhead
Does it cycle in/out in diagnostics? Have you checked pneumatics to to the RS cylinder?
Electronics Forum | Thu Feb 14 23:08:41 EST 2013 | dekhead
Squeegee error on a 248 is strictly that sensor (reed SW) on corresponding (Front / rear) squeegee cylinder is not seeing a change in state... Either a physical obstruction preventing cylinder from exending fully - OR- if it is extending fully, then
Electronics Forum | Wed Mar 15 14:18:24 EDT 2023 | klauss
first, brand new nozzles work good but after a while they also give an error. but later they're not working again. it's like a cycle
Electronics Forum | Thu Jun 08 18:40:44 EDT 2017 | simons
We have a Samsung that we have replaced all the amps and are still getting the Z axis motor alarm failure. On the “Position Window” before and after we try to “Home” the machine, the values for “Z-Axis” for all three heads prior to the “Home” action
Electronics Forum | Wed Jun 19 18:44:56 EDT 2019 | dekhead
Is the signal making it to the SOL? Is it toggling when signal is present? RS Cylinder is to the rear of the RS rails.
Electronics Forum | Thu Jun 20 10:23:47 EDT 2019 | key
Would you happen to have a picture of the RS Cylinder and Rs rail. When we send the table in sol 4 is on. When we try to send the table out sol 4 and 5 are on. We are having a hard time finding the RS Cylinder and RS rail
Electronics Forum | Wed Jun 19 11:26:06 EDT 2019 | key
We have been looking at the Sol for the in and out and the up and down for the blades. We moved the sol around with no change. where is the RS cylinder located in the DEK 248.
Electronics Forum | Thu Jul 18 13:15:25 EDT 2019 | dekhead
I guess you were able to locate the RS cylinder. Assuming adjustments to RS flow controls was your resolution.
Electronics Forum | Thu Nov 03 01:39:53 EDT 2022 | spacecase
Thank you for the response, left the machine turned off for a good period of time and somehow the issue solved itself. I was able to calibrate the next day and homing hasn't been an issue. However now I'm having another problem where it gets 4 comple