Electronics Forum | Fri Aug 24 07:21:51 EDT 2012 | leemeyer
The barbed fitting will work but you will lose all control over the speed of the cylinder. The air control flow valve is essentially the same as the barbed fitting but it allows the user to adjust the volume of air that is supplied to the cylinder wh
Electronics Forum | Tue Oct 27 22:46:21 EDT 2009 | fulldrawmike
if your feeder is indexed via an air/pneumatic cylinder like say a bimba? put a couple of drops inside the cylinder via one of the fittings, index it a few times and see if it does not pick the pace up some. don't oil the index shaft, could cause t
Electronics Forum | Wed Sep 12 10:49:46 EDT 2012 | cyber_wolf
Sounds like the feed cylinder sensor. Its a air cylinder hooked to the tape feeder advancing mechanism in the rear of the machine. Go into the I/O and make sure the sensor is changing state when you flag it.
Electronics Forum | Thu Feb 14 23:08:41 EST 2013 | dekhead
Squeegee error on a 248 is strictly that sensor (reed SW) on corresponding (Front / rear) squeegee cylinder is not seeing a change in state... Either a physical obstruction preventing cylinder from exending fully - OR- if it is extending fully, then
Electronics Forum | Fri Sep 20 19:06:09 EDT 2002 | mjabure
The way it works is the first index is done with the feed cylinder, and the final is done using the cam during pick. You might want to check to make sure you're getting a full, complete stroke out of your feed cylinder, also make sure the mechanism
Electronics Forum | Fri Sep 20 09:07:21 EDT 2002 | cyber_wolf
You are right. It is getting indexed twice. Once by the feed lever and once by the feed cylinder.
Electronics Forum | Thu Dec 26 17:01:59 EST 2002 | alandra516
Store the flux stone in PVC pipe (capped at the end) and fill the pipe with Isopropyl Alcohol.
Electronics Forum | Thu Mar 16 11:33:52 EST 2006 | cyber_wolf
When I flip the switch to lock the stencil, the magnet in the carriage cylinder pops free..... Any ideas ?
Electronics Forum | Thu Apr 16 05:50:25 EDT 2015 | sarason
Do you mean a 24V Linear Actuator ? sarason
Electronics Forum | Thu Jun 13 20:03:05 EDT 2019 | dekhead
Does it cycle in/out in diagnostics? Have you checked pneumatics to to the RS cylinder?
