Electronics Forum | Wed Apr 11 17:00:28 EDT 2012 | rodrigo
Hi all, Our cp4 moves rather violently (jerks) all axis when the reset sw is pressed after power up. I've got all sorts of errors after boot up: Servo amp error: D,X,Y, etc Overtravel D,X,Y, etc D clutch error, power off machine We've checked all
Electronics Forum | Wed Jul 26 22:47:14 EDT 2006 | seth
I have problem with RV/D axis counting error. I have tried several things, but it just doesn't help. These are the things I had tried 1. Check all 12 segment for dirty. 2. Check DP motor for proper operation. 3. Replaced reader. In order for me to pe
Electronics Forum | Thu Jul 27 09:48:16 EDT 2006 | john_smith
Seth, have you tried the zero point on the star?
Electronics Forum | Sun Jul 30 11:50:22 EDT 2006 | john_smith
Do the sleeves spin freely in the segment? Could also be that the reader needs to be readjusted.
Electronics Forum | Tue Aug 01 17:12:48 EDT 2006 | seth
My problem solved. I had to re-adjusted the reader,
Electronics Forum | Wed Aug 02 06:39:13 EDT 2006 | john_smith
Good Job!!
Electronics Forum | Wed Oct 26 11:54:31 EDT 2022 | proceng1
To me, it sounds like your axis servo is losing steps. Can you get through the calibration steps? Hanwha is who we use for service. I'd say call them if you don't want to just throw parts at it.
Electronics Forum | Thu Jul 27 17:18:43 EDT 2006 | seth
Yes, I have but if I don't then I won't be able to reference run.
Electronics Forum | Mon Jul 31 21:33:58 EDT 2006 | seth
What is the distance from the reader to the segment, and can you use a filler gauge to set the gap or is there a special tool needed?
Electronics Forum | Tue Feb 05 19:00:18 EST 2013 | marcelorotofrance
I found problem, it was a faulty connector on the align processor card. So, Mr. Bobpan, I thank you very much for your invaluable guidance. P.S. My employer has been very clever and have purchased a 18 years old/ 25000 run hours/ third-hand equipmen
