Electronics Forum | Wed Nov 03 12:57:28 EDT 2010 | adrianam
I need some help with the following alarm appeared on Fuji FCP4-3 : ,,Servo Amplifier alarm on X, Y, C, Z axis". When I push the reset button, remain ,,Servo Amplifier Alarm on D, F theta axis". All the sensors and solenoid it were checked and is OK
Electronics Forum | Wed Jan 13 20:44:42 EST 1999 | Steve Gregory
Hello Sanjay! The cheap deal I use that Earl spoke of is called a SMarT Measure. It's a depth measuring microscope that uses the same principle of measuring optical focus that the units from Vision Engineering do ( if you've ever looked at any
Electronics Forum | Thu Jan 14 11:08:29 EST 1999 | Mike McMonagle
Steve, Whoa, take a breath! That was at least a dollar three-eighty answer. I've got to agree that nothing can replace a qualified, concientious operator for assuring quality. When I too worked at a small shop there in SillyCone Valley, my seni
Electronics Forum | Thu Jan 14 15:22:14 EST 1999 | Earl Moon
| Steve, | Whoa, take a breath! That was at least a dollar three-eighty answer. I've got to agree that nothing can replace a qualified, concientious operator for assuring quality. When I too worked at a small shop there in SillyCone Valley, my
Electronics Forum | Fri Jul 17 19:43:20 EDT 2009 | fujiphil
Have you eliminated the hardware N.G.? Check the connection for the rear door. If the connection are ok, try to bypass the key. short the two wires for the rear door. If the rear door problem is corrected, check the rear door switch physically. Reg
Electronics Forum | Mon Jul 13 10:04:06 EDT 2009 | csm
Dear all, we have an Fuji CP6-4000 we get some weeks ago, but it shows an error "Hardward NG and show some actions (Inch the axis to cancel the overtravel. Then switch the power off and restart the machine). We did but display same error. I would li
Electronics Forum | Tue Jul 13 14:25:57 EDT 1999 | Earl Moon
| | | | Hi, | | | | | | | | I need some urgent informations on stencil design guidelines on how to perform epoxy printing on 0603 and 0402 components. Could anyone help? ( Reflow process is not possible because of some other constriants) | | | | |
Electronics Forum | Wed Jul 14 21:34:16 EDT 1999 | karlin
| | | | | Hi, | | | | | | | | | | I need some urgent informations on stencil design guidelines on how to perform epoxy printing on 0603 and 0402 components. Could anyone help? ( Reflow process is not possible because of some other constriants) | |
Electronics Forum | Thu Jul 15 14:38:38 EDT 1999 | JohnW
| | | | | | Hi, | | | | | | | | | | | | I need some urgent informations on stencil design guidelines on how to perform epoxy printing on 0603 and 0402 components. Could anyone help? ( Reflow process is not possible because of some other constriants)
Electronics Forum | Mon Jul 13 09:34:32 EDT 2009 | csm
Dear all, we have an Fuji CP6-4000 we get some weeks ago, but it shows an error "Hardward NG and show some actions (Inch the axis to cancel the overtravel. Then switch the power off and restart the machine). We did but display same error. I would
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
.gif)
winsouce.jpg)