Electronics Forum | Tue Mar 27 11:33:45 EST 2001 | sim_ad
I have some boards here that were damaged by solder on the goldfingers. Is there a place I can contact to repaire them? Please advise. Simon
Electronics Forum | Tue Mar 27 12:44:36 EST 2001 | Mike Lynn
Try Veeco Electrofab (714)525-6257 (Anaheim, CA) - ask for Jack Singh.
Electronics Forum | Tue Apr 06 12:55:01 EDT 1999 | Patrick O'Connor
0603's and 0402's are being damaged by the water wash post reflow. PCA's are 1" X 4" and 2" X 2" approximately. We've adjusted water pressure so that the top-down is higher than the bottom up. The baskets have a .5" mesh spacing. Some baskets h
Electronics Forum | Tue Apr 06 16:22:58 EDT 1999 | Dave F
| 0603's and 0402's are being damaged by the water wash post reflow. PCA's are 1" X 4" and 2" X 2" approximately. | | We've adjusted water pressure so that the top-down is higher than the bottom up. | | The baskets have a .5" mesh spacing. Some
Electronics Forum | Tue Dec 06 02:59:09 EST 2005 | darek
Lately we purchease second hand CSM 84V. During placing parts, we notices that few components are damaged (mmelf, 0805). What we done: - the position of pcb was decreased - the jaws moved little bit outside. Components after that are still damaged. H
Electronics Forum | Mon Sep 18 08:48:06 EDT 2023 | dorrissmith
Ok, thanks.
Electronics Forum | Mon Nov 19 10:18:03 EST 2001 | gzweig
There is no question but that x-radiation is an ionizing radiation and can effect components sensitive to ionization . The higher the power level of the x-ray source, the higher the amount of ionization taking place. At low levels of x-ray we have ne
Electronics Forum | Tue Sep 12 11:50:12 EDT 2023 | ttheis
I heard a similar story from a colleague on these machines. Same thing- head and beam not secured for transit and banged around whole trip. I think the beam ended up bent in that case and the machine could never be calibrated or repaired. Don't know
Electronics Forum | Mon Nov 19 11:59:54 EST 2001 | seand
Hello everyone, Is it possible to quantify what you consider "Low Level" vs. High Level x-ray exposure? Is anyone aware of what level of exposure the airlines typically use in security applications? Thanks, Sean
Electronics Forum | Tue Dec 06 04:38:43 EST 2005 | mskler
check the placement height of the head, That can be checked by manual up & down of head on conveyor the nozzle should just soft touch the conveyor. Also check the down speed of head.
