Electronics Forum | Wed Mar 05 12:42:46 EST 2003 | scifi97
Thanks for the questions/interest Mike. I only work with the data provided by customers myself and do not know a lot about how it is generated, other than a vision inspection machine looks at a completed card and provides the x,y and theta variation
Electronics Forum | Tue Mar 04 18:49:06 EST 2003 | scifi97
Hi Mike, I have had a number of contract manufacturers, and SMT equipment makers looking at using our SPC software to monitor process control on SMT machine production with the data coming off the vision check machines. (There seems to be a huge sur
Electronics Forum | Wed Mar 05 13:37:20 EST 2003 | msivigny
Hello James, It sounds like the system that's being used to gather this data is an AOI system. I will investigte this more because I'm very curious of the process in which this works. I'll keep an eye out for someone using this setup and may get back
Electronics Forum | Wed Mar 05 10:10:27 EST 2003 | msivigny
Hello James, That sounds very interesting. I didn't know a system like this was available. What is a vision check machine? Is it a software monitoring tool that is installed on manufacturers equipment to evaluate the conditions you mentioned? I'd lik
Electronics Forum | Thu Apr 03 11:36:54 EST 2003 | stefwitt
I don't know too much about Fuji, but I'll try myself anyhow. How is the coplanarity unit communicating with the machine controller? Attach a logic analyser, second listener or data analyser and "listen" to the communication with the machine contro
Electronics Forum | Wed Apr 09 11:42:39 EDT 2003 | stefwitt
Ricardo, I can�t apply more then common sense to the function of the coplanarity system. If Fuji buys the system off the shelf, from Cyber Optics for example, then it is very likely that it has its own processor, programmed a way that the measuring r
Electronics Forum | Fri Apr 04 16:56:50 EST 2003 | RicardoF
Thankyou Stefan, somehow the Laser sensor and controller are addresed to the IP, but it seems the results are simple as an OK or some codes when the part is out of specs, those codes appears on the monitor in the machine just for a while, likely the
Electronics Forum | Wed Jan 24 21:29:43 EST 2007 | davef
Board fabricators commonly use Barco AOI to inspect film. The AccuMatch compares pixel-to-pixel of the Gerber data to the image seen by the AOI camera. It's slower than design rule checking, but has definite advantages [like lower falsing]. Unfortu
Electronics Forum | Mon Jul 26 03:32:31 EDT 1999 | Jason
| | | Hello, | | | i'm looking for informations about companies which are using system to verify the loadind of a SMT machine by using barcode (on the slot on the machine & on the reel). | | | I'm in charge of the installation of this kind of system
Electronics Forum | Tue Apr 12 23:44:51 EDT 2016 | cmarasigan
Try to increase or set to 100% the Lead Check Side (%) for every QPF part data.
