Electronics Forum | Mon Jul 26 03:32:31 EDT 1999 | Jason
| | | Hello, | | | i'm looking for informations about companies which are using system to verify the loadind of a SMT machine by using barcode (on the slot on the machine & on the reel). | | | I'm in charge of the installation of this kind of system
Electronics Forum | Mon Jan 16 19:24:54 EST 2023 | linux
don't have nozzle data for this nozzle. checked with panasonic no data available
Electronics Forum | Sun Oct 11 10:00:11 EDT 2015 | brockparry
if you are facing a problem to send the data to your machine then you must check the driver part of your machine if you are sending it through any software. Also check the power status of the machine. You can also go for one simple method by doing Re
Electronics Forum | Wed Aug 26 17:06:56 EDT 2009 | andoe
when i transmitt data to the cp6 every thing seems to go okay until the end and i get a -- "A21E transmission error". i have checked the cable (i can program my IP3) any ideas? thanks ron
Electronics Forum | Fri Nov 18 02:42:46 EST 2005 | vinitverma
Greg, I recently faced this problem at a customer though the machine was Topaz X but the problem was same. So I suggest you first check if the GOOD LED is ON on the Servo card down in the MCX box. Also check the same GOOD LED on the System board in
Electronics Forum | Thu Nov 15 19:56:18 EST 2012 | rgduval
I would have said it sounded like a motor/encoder problem...but, since you found the broken resistor, that was likely the source of your issue. The resistor and capacitor are a filter for the motor, MyData likes to put them on nearly all of the moto
Electronics Forum | Fri Sep 26 12:16:52 EDT 2008 | bickt
you cannot swap 0-3 only 0-1 or 2-3 they are not the same euro cards. they function very diffrently. if you look you will see there are more chips and circuitry on one set. there are 2 w/red leds and 2 with green leds. at least thats how they soo
Electronics Forum | Sat Aug 08 09:45:11 EDT 2015 | edwaterfall01
It would be helpful to know what happened before the error occurred. Do you have another machine so that you can swap some boards? The Force CPU, (machine controller) located in the VME, is responsible for controlling all machine-related activities.
Electronics Forum | Thu Feb 20 13:56:18 EST 2014 | rgduval
Brendan, Unfortunately, I no longer have MYData equipment in my shop (I moved to a new company), so, I can't help with finding part numbers. I do know that you can buy the motor/counter units separately on the open market..and, I think you can buy
Electronics Forum | Mon Apr 08 15:07:56 EDT 2024 | tey422
To me, it seems like there are slightly XY offset. Hydra might be able to pick up the tips, but not all the way securely attached to the hydra tubes. So, when the tips put back are not fully seated, which causing the tool stick inside the bank. You
winsouce.jpg)