Electronics Forum | Wed Jul 06 09:51:23 EDT 2005 | Jack
Doug, It always seems easier to fix one or two problems by eye at the time. The real problem comes when the customer wants the same board run again later. You're okay if you saved the corrected placement routine, but if you end up moving the job t
Electronics Forum | Wed Jan 11 10:12:23 EST 2006 | ratsalad
I've used an old version (maybe 7 or 8 years old) of GC-Place to convert gerber to centroid data. It is semi-automatic. If I remember correctly we'd start by selecting the pads for the largest components first. The software would find matching gro
Electronics Forum | Mon May 25 20:31:32 EDT 2009 | dcell_1t
wich is the model of the machine you're trying to place this component? what are the placement issues that youre observing. on the IP3 that we place switches we use a 3.7 nozzle (standard) because of the dimensions on the component, the issue that I
Electronics Forum | Fri Jun 23 21:10:29 EDT 2023 | meher
To resolve this issue, you need to ensure that the proper data is stored and transmitted to the MTU. Double-check the communication settings between the machine and the MTU during the startup process. Make sure that all the necessary data is being se
Electronics Forum | Thu Mar 05 23:04:44 EST 2020 | sarason
My advice for what it is worth. Your description of the problem at first glance suggests a communication problem, now is it the bus, the SMT machine or the PC. The bus could have a short or an open. The PC could have a dud controller card. or so co
Electronics Forum | Wed Dec 07 02:35:28 EST 2011 | mk15
Hi, I am looking for help with Error Philips Comet, Start Procedure -OK, INTIAL SERVO ORIGIN -OK, AUTORUNNING -OK, PCB START -OK, FIDUCIAL -OK, PICKUPCOMPONENT -OK, NEXT-ERROR E2 CORRECTION DATA ERROR(CORRECTION DATA IS NOT LOADED OR FAILED TO ADJU
Electronics Forum | Wed May 27 18:19:58 EDT 2009 | dcell_1t
yesterday I tried with vision type 20, just defined the two pair of leads and error 1CA14003 came up, on flexa error help says the following: Cause: The Vision_type in part data is expressed using hexadecimal notation (??). If ?? equals 0A, 0B, 0C,
Electronics Forum | Tue Mar 20 19:18:53 EDT 2007 | diesel_1t
Hi to all, thank you very much for your feedback. The part is rotated before inspection; and also tend to be shifted to the same direction of pre-rotation so i think is not correcting misalignment or maybe some settings on shape data are not correc
Electronics Forum | Fri Jul 19 11:02:15 EDT 2019 | dman97
You never answered my question on the proper data. Do you have a hard copy of the proper data? Is the diskette (if you have it) in Fuji Flexa format? In order for flexa to communicate with the CP6, you must have the correct proper data.
Electronics Forum | Mon Jan 29 03:33:33 EST 2007 | sami
thanks I haven't the same shift in all the components, that's why I need to correct them one by one and this takes a lot of time. I am searching in the Software of the machine if there is any way to change just one parameter to correct all the data
