Electronics Forum | Wed Dec 28 12:42:25 EST 2005 | pfifla1
I direly need a Dynapert dd4500 setup jig if somoene has one they can sell or let me use for a fee so i can get one made at the machine shop, please let me know.
Electronics Forum | Thu Jan 05 11:13:31 EST 2006 | JOE
joseph.gurley@gmail.com
Electronics Forum | Thu Dec 29 09:31:45 EST 2005 | pfifla1
I need the bug for the machine, if you could send me over the measurement i would try to get it made. would your owner consider releasing it if i gave him funds to secure its return and then paid him for the time i used it.
Electronics Forum | Fri Dec 30 05:50:12 EST 2005 | JOE
any chance i could trouble you for a picture to give to my machine shop.
Electronics Forum | Tue Jan 03 09:05:31 EST 2006 | DannyJ
Hi Joe, Sorry for the delay, been off on holiday... Just give me an email address and I'll forward one before the end of today. (Make sure to add something like removethis in the email, not sure if this list is crawled...) Dan
Electronics Forum | Thu Dec 29 09:32:30 EST 2005 | pfifla1
I need the bug for the machine, if you could send > me over the measurement i would try to get it > made. would your owner consider releasing it if i > gave him funds to secure its return and then paid > him for the time i used it. dan please s
Electronics Forum | Thu Dec 29 10:54:29 EST 2005 | DannyJ
Hi PFI, Sorry, the owner probably will not go for shipping the bug. We have 4 plates here, but only one bug for the dip and one for the VCD's. I'll do my best to get you the information needed, though... The part # is DIP-561 and is $500 USD fro
Electronics Forum | Thu Dec 29 11:28:14 EST 2005 | DannyJ
Measurements: Block is .680" x .680" x .125" 4 dowel pins: .026" diameter x .250" length Center to center measurements on block where dowel pins are inserted: .600" x .600" Let me know if I can be of any more assistance. Dan
Electronics Forum | Wed Dec 28 15:07:20 EST 2005 | DannyJ
Do you need the 'bug' or the plate? The plate is what goes onto the table and the bug is what you put into the upper jaws... We use the 4500 and I may be able to help you out. If you only need the bug, the width is .300" and I can get a measuremen
| 1 |
.gif)
