Electronics Forum | Tue Aug 01 09:49:53 EDT 2017 | dontfeedphils
Our Engineering team handles all initial programming and debugging of programs on the floor, with a person "specializing" in a certain area, but with all Engineers cross-trained well enough to take on the job if need be. Technicians are responsible
Electronics Forum | Sat Nov 07 10:09:52 EST 2009 | ramses2001
Hi Nemo, In my factory we have an offline AOI from VISCOM for two SMT lines. It's not so easy to program, but the results are very good. Anyway you should have to think that an AOI system needs a human inspector and a technician to debug the program
Electronics Forum | Wed Dec 13 08:56:49 EST 2000 | CAL
One other piece would be to map of the hot spots in the US market. California, NE, SE, Chicago and Texas are hot spots for Electronics manufacuring. Target companies in these areas and hit them with resumes. Some areas are starved for manufacturing e
Electronics Forum | Wed Jun 26 21:41:46 EDT 2002 | ianchan
Hi mate, "no more than 6hrs in the stencil" for us means: 1) we finish setup of reflow oven, P&P m/c, and lastly the printing machine(includes loading of stencil into printer machine). 2) once printer machine is setup, we rip-open the paste Can pr
Electronics Forum | Sat Apr 09 23:14:36 EDT 2005 | MikeaJ
In response to the post concerning the UP1500, the case is a little different. The Speedline/SMTech passwords are hardcoded into the Sigpro.exe file. Here is what you need to know: Login name: Speedline (or SMTech) Passwords are listed in order of ri
Electronics Forum | Sat Jun 08 13:16:06 EDT 2013 | unisoft
Take a look at the Unisoft software ( http://www.unisoft-cim.com ). For over 25 years this software has in use by Electronics Manufacturer CEM/EMS's and OEM's to automate New Product Introduction (NPI). It's perfect for Electronic Contract Manufact
Electronics Forum | Wed Apr 04 10:32:10 EDT 2018 | dleeper
At an EMS I used to work for, our process for first article inspection was to have a human technician do a point to point comparison between the BOM and the PCB. They would verify component part #s were correct per the location, correct polarity and
Electronics Forum | Thu Apr 27 08:42:22 EDT 2017 | pvasquez
Hello M. We are a low volume high mix manufacturer with a total of 7 Mirtec AOI machines including a new MV-6 OMNI 3D system. I am very pleased with this machine! When we did our 3D AOI research, my team narrowed the field down to 2 vendors, Mirt
Electronics Forum | Thu Nov 30 11:20:55 EST 2006 | CK the Flip
I'm no guru, but I am among the best that my home state's gotta offer... :-) Anywho.. a Production Manager's definition of cycle time is the time Production Planning schedules the stockroom to start picking materials for the work order, to the time
| 1 |
