Electronics Forum | Thu Sep 19 21:46:01 EDT 2002 | scottefiske
In the past year I was responsible for developing and leading a Team focused on AOI, Evaluation, Justification, and with a full ROI required, supporting a HMLV manufacturing environment. If you have in these economic times the additional resources t
Electronics Forum | Fri Aug 03 17:00:57 EDT 2001 | mparker
Start with a definition of what you expect the AOI to achieve at each station. Will your in-line machine be post print? Place (pre-reflow) or post reflow? Rather than buy one very expensive machine to put at the end of the line, maybe a couple of
Electronics Forum | Tue Nov 06 06:23:31 EST 2007 | clampron
Good Morning Roger, The Mirtec's can be adjusted to lower your false call rate. This can be done by reducing the matching percentage for each componnent but the result of this action is that the machine becomes less selective. If you lower them too
Electronics Forum | Sun Aug 09 15:25:17 EDT 2015 | dev88
dear sir i am new for aoi section,my work will be teaching of aoi defect and related to programming, want to know how to make program easily in mirtec 4.1.1 and what are the different standard which we must understand.
Electronics Forum | Wed Apr 19 04:38:49 EDT 2006 | ge_lim
Hi Refering to the Apr edition of SMT , page 24 to 29, anyone got experience on implementing the AOI or 3D x ray : a) What is the pros and cons? b) What is the trend in the PCBA industry for wave soldering inspection? c) Will this implementation co
Electronics Forum | Mon Apr 24 15:11:11 EDT 2006 | pjc
For solder joint inspection you cannot beat AXI. That's what is was designed for. AOI machines were designed for component inspections and solder joint checking was an add-on. In transmission AXI you can get a measurement of the whole solder joint. A
Electronics Forum | Wed Aug 30 07:34:23 EDT 2006 | Xray Tester
For Automated x-ray inpsection system comes in 2D and 3D. 2D also know as the transmission xray inspection where xray are generated from a fixed point source. On double side board, this does not work that well. That where 3D Automated x-ray inpsectio
Electronics Forum | Fri Apr 21 18:43:23 EDT 2006 | SD
Sorry, I have not read the article. However, I do have five years experience constantly tweaking an AOI system that ran ONE product! The strength of the machine was solder inspection. The biggest problem was component color variation and shadowing
Electronics Forum | Thu Jun 13 08:10:51 EDT 2024 | carl_p
You would need to be more specific on the AOI in question here. 2D, 3D features will also have a big impact. Are you constantly evolving or updating the models to improve the situation or going from just the base program as if low volume it can be a
Electronics Forum | Wed Jun 19 14:40:58 EDT 2024 | davidk
Hello Carl, Thank you for your comment Obviously, we are evolving and debugging our test to get the best results ("no escapes no false calls") :) and using a combination of 3D and 2D tests. With the previous AOI, we had a much higher false call rate,
