Electronics Forum | Thu Sep 10 09:47:15 EDT 1998 | Earl Moon
| hi, | 1206 capacitor with silver/palladium termination is mounted onto a ceramics substrates. Bonding is achieved through conductive epoxy. | We discovered that the epoxy cracked and this caused missing capacitor. We had tried different grade of e
Electronics Forum | Wed Sep 09 21:20:26 EDT 1998 | Simon Ting
hi, 1206 capacitor with silver/palladium termination is mounted onto a ceramics substrates. Bonding is achieved through conductive epoxy. We discovered that the epoxy cracked and this caused missing capacitor. We had tried different grade of epoxy,
Electronics Forum | Thu Aug 04 19:00:25 EDT 2022 | SMTA-64386637
I am investigating the use of conductive epoxies to connect battery leads, Charging pins and wires inside small plastic housings. Soldering in these small spaces can create heat related defects in the plastics even when using low temp solders. Are
Electronics Forum | Fri Apr 25 08:48:25 EDT 2003 | davef
If what you say is accurate, two thing come to mind: * Pads on the board are incorrect for the tombstoning components. * Profile is different on the individual pads of tombstoning components. We have heard of, but never seen, components [tants] that
Electronics Forum | Mon Dec 08 14:40:08 EST 1997 | Rin Or
| First Responses Lost: Please Repost | | Looking for info on process flow for 2 sided SMT with PTH | | on the top side. | | Both sides have large SMT ICs. I don't know what the best approach is; | | Epoxy, Paste in Hole, High temp paste. | | Any in
Electronics Forum | Thu Mar 04 18:18:02 EST 2004 | Ken
There is a japanese company that makes a ultrasonic hand-held stencil cleaner. I demo'd it for a day and it was fantastic! It even cleaned epoxy stencils. Can't recall the price...but it should be much much less than the smart sonic and other "mac
Electronics Forum | Tue Aug 27 03:45:36 EDT 2002 | seje
Hi there. We are considering to attach die chip with solder paste to the pcb at the SMD line (we are used to attach it with silver epoxy at the die bonding line before). This is a whole new method to me, so I'd like to have some opinions here. Where
Electronics Forum | Mon Jun 18 10:14:30 EDT 2001 | surachai
HI ALL; I WOULD LIKE TO KNOW THAT ANYBODY CAN RUN GLUE PRINTING PROCESS WITH 0402 CHIP AND PASS THEM TO WAVE SOLDERING PROCESS ,PLEASE GIVE ME THE INFORMATION ABOUT THEM . 1)HOW WIDE OF APERTURE DO YOU OPEN ON YOUR STENCIL? 2)HOW MANY YIELD OF THIS P
Electronics Forum | Fri May 29 17:48:34 EDT 1998 | Earl Moon
| | | We recently made the switch to no-clean and the wurface mount is turning out beautifully. However, the wave solder process continues to put up a fight; we are getting a white residue on the surface of the PCB. The residue is not localize
Electronics Forum | Sat May 30 08:24:09 EDT 1998 | Dave F
| | | | We recently made the switch to no-clean and the wurface mount is turning out beautifully. However, the wave solder process continues to put up a fight; we are getting a white residue on the surface of the PCB. The residue is not locali