Electronics Forum | Tue Jun 06 07:39:46 EDT 2000 | Mark Alder
Just short note to say Hi.Please send me your private e-mail address. Regards Mark Alder
Electronics Forum | Fri Mar 26 19:32:05 EST 1999 | Martin Dunning
I am a student doing a project on rework os BGAS and CSPS and Im looking for information on it especially rework of csps Has anyone got x-ray images of csps after rework or of BGAS to show csps with solder balls Appreciate any help Urgent!!!!
Electronics Forum | Tue Sep 28 07:46:30 EDT 1999 | g cronin
if anyone has used or has one of these bga rework stations please give me your opinion on them. I am planning on using the sytem for not only rework but also low volume prototype production for hand built 1 or 2 qty pcb's, so ease of use is importa
Electronics Forum | Wed Jan 17 09:32:09 EST 2007 | Jeff
Hi, I am having problems reworking a lead free PBGA (23mm x 23mm, 1mm pitch). The board is relatively small (5" X 4" X 0.063"). During the removal stage, a thermocouple was placed at the solder ball level (between the board and underneath of compo
Electronics Forum | Thu Jan 18 08:26:49 EST 2007 | Jeff
So you are suggesting to begin heating using a preheater only . . . then when the thermocouple under my PBGA reads around 130C, turn on a top side heater? Thanks
Electronics Forum | Thu Jan 18 08:31:09 EST 2007 | Jeff
Thanks. I will turn off the machine activated cooling and have the part cool down at room temp (no compressed air cooling). Can you recommend a good paste / tacky flux?
Electronics Forum | Fri Jan 19 11:42:40 EST 2007 | russ
yeah Jeff, i would make sure that you are not overheating part trying to get the balls to temp. Indium will sell you a couple of these cartridges for sure. Good Luck Russ
Electronics Forum | Thu Jun 01 21:59:10 EDT 2000 | Ray Chartrand
Does anyone know the current cost to repair a defective solder joint? I seem to recall a number quoted a few years ago of $1.03 per joint with burden of overhead. I've also seen numbers from 50 cents to 50 dollars per joint.
Electronics Forum | Wed Jan 17 17:09:43 EST 2007 | russ
appears to be incomplete reflow on a couple of balls or they were moved during a cooldown. it also seems as though there is a deviation in ball size due to inconsistant paste application possibly. I would stop applying paste and just reflow that pa
Electronics Forum | Thu Jan 18 13:13:53 EST 2007 | russ
won;t recommend a paste since I propose that you do not use but here is a flux I have had great success with Indium tacflux 20B IPN 84283 No clean flux, Use this alone without paste and your BGAs will work!! What was your package temp during th
