Electronics Forum | Thu Mar 17 09:53:20 EDT 2011 | rperkins
Hi Graham, I've worked in the industry selling EnSolv, Lenium, and now ENTRON solvents, which are all based on stabilized NPB. These solvents do not always clean the no lead pastes. The problem is that the pastes are becoming more like adhesives,
Electronics Forum | Thu Mar 17 15:34:35 EDT 2011 | grahamcooper22
Dear Rick , thanks for your reply. It is very helpful. I'll get chance to try the Ensolv in a lab next week to see if we can remove the paste residues. Thanks again
Electronics Forum | Wed Oct 12 12:05:17 EDT 2011 | dphilbrick
It melts many plastics but not harmful to electronic components. to use it properly you need a vapor degreaser.
Electronics Forum | Thu Aug 08 08:45:07 EDT 2013 | benreben
if is regardless of fluxes or population complexity my opinion is that inline aqueous with kysen liquid or other is the best because this liquid wash all type of flux and the aqueous wash all population complexity
Electronics Forum | Thu Sep 03 19:48:36 EDT 2020 | charliedci
Not in our case, the pre-heat temp was not high enough. Also our pre-heat is only from top (KISS104).
Electronics Forum | Tue Sep 08 10:45:26 EDT 2020 | charliedci
We've had to hand solder 1 or 2 pins in cases like this or you could use chip bond or some adhesive on the component body.
Electronics Forum | Thu Oct 04 21:52:34 EDT 2001 | sjlevin
If you do not have one of the big in-line aqueous cleaners, then there is an easier way that is a lot less expensive. I suggest you try Asahi's AK-225T vapor degreasing solvent which has been around for 10 years now. And it is legal. If you have
Electronics Forum | Tue Jan 10 14:04:38 EST 2006 | Mike Konrad
Flashback time� Vapor degreasers, although still used in limited applications, no longer represent the conventional wisdom (due to multiple environmental issues). Aqueous-based technologies are the most common method of defluxing. Unlike most va
Electronics Forum | Wed Aug 31 12:00:59 EDT 2011 | cpitarys
Vapor phase or vapor degreasing cleaning for electronics is simple technology that holds merit on process situations like you described. Easy and quick to set up and process with today's modern equipment you can be up and running in no time once the
Electronics Forum | Fri Sep 28 02:48:46 EDT 2018 | teresat2
Principle A layer of photosensitive material (photosensitive oil or dry film) is applied to the copper foil on the board surface, and PCB manufacturer should be use the position is exposed by black film, This applies to most PCB factories, especially