Electronics Forum | Tue Sep 16 13:43:48 EDT 2014 | gascon5383
We have new stencils produced every 15000 prints. Another technician takes care of that and he uses gerber files to have them produced. Also, we have over 300 different products that are produced, all board sizes are standardized 287mm long x either
Electronics Forum | Mon Mar 03 11:37:34 EST 2008 | lysik
OK I'm a tech and I would not start with replacing both a computer and a camera. spend as much time with tech support as possible via telephone that is what they are there for. If they can't help keep posting this message. The good old stand by is to
Electronics Forum | Tue Mar 04 10:54:50 EST 2008 | vikkaraja
I think so,but what do you mean if hard drive is ok. Please explain.Computer boots up ok and machine even goes through it's complete intialization steps. I was thinking the same way as you are to start replacing one componet at a time. what do you th
Electronics Forum | Thu Mar 06 09:19:53 EST 2008 | d0min0
Two way to check a HardDisk: 1. run a dedicated software check (each brand should have one soft) or run a test-benchmark that You can easily find on web 2. make "ghost" image of HD and then replace a HD with same size (GB) and put the image on new on
Electronics Forum | Mon Sep 15 10:22:45 EDT 2014 | island2013
Sounds like all the usual suspects have been replaced. How about some completely random thoughts. For this specific product, you mention it runs a few boards then fails out. Does it fail out on one specific fiducial on this product every time or i
Electronics Forum | Tue Sep 16 15:54:39 EDT 2014 | gascon5383
I have not tried running it 180 or 90 degrees out. The process involved to change that would be too large for my company to accept it. I see where you can adjust the board stop x and y but is there a way for the z axis? I have found that the board is
Electronics Forum | Tue Sep 16 09:39:33 EDT 2014 | emeto
Hi there, It looks weird how you handled the problem. Just a thought, but would you check the stencil and may be recut a new one, making sure you have the image exactly in the center and have the fiducials exactly where you want them and the frame
Electronics Forum | Fri Aug 28 11:59:05 EDT 2015 | gascon5383
Actually I should have noted we resolved this issue. After chasing our tails for a while, we found that somehow there was a static charge on the boards going into the machine. This static was discharging to the camera through the board stop, causing
Electronics Forum | Tue Sep 15 19:21:38 EDT 2020 | edvardvojvoda
Because after we set the reference point at the right place, the program is working. The problem is.. the DEK try to find the reference point at different locations, it happens mostly at changeovers and sometimes before the fiducial check. When it l
Electronics Forum | Tue Sep 15 17:03:18 EDT 2020 | edvardvojvoda
Hello! We have a DEK Horizon 03i paste printer. When we load a new program at change over, most of the time it lost the reference point for the camera axes. After that the fiducials coordinates changed automatically to minus values. The service said,
