Electronics Forum | Wed Aug 31 09:35:15 EDT 2016 | dekhead
Certainly possible CPU board issue; but check PC power supply, that all DCV are present and strong. www.dekhead.com
Electronics Forum | Thu Sep 01 09:08:04 EDT 2016 | dekhead
Yes, wired correctly (5, 12, -12) can easily run on a standard 300W computer PSU.
Electronics Forum | Fri Sep 02 04:18:48 EDT 2016 | bukas
i have tested voltages on Processor board X12. all voltages are ok and stabil but +VPP (PT8 - TP9), it reads 0 volts
Electronics Forum | Wed Nov 20 12:56:58 EST 2002 | jasper
In my opinion MPM is superior as far as programming the 2D inspection. It's fast, simple and reliable. The DEK has options like Formflex. The MPM only offers adjustable vacuum box. It's difficult. 2nd hand prices are not similar. We offer used/refurb
Electronics Forum | Tue Nov 26 09:19:29 EST 2002 | pjc
MPM UltraPrint 2000 2D Inspection Times: QFP 256 pin 16Mil pitch is 7.5 seconds BGA 225 ball 20Mil pitch is 1.8 seconds Find out the DEK times for these devices. Any UP2000 of 1995 mfg. date oand on can be upgraded to the latest software. Concer
Electronics Forum | Tue Jun 01 16:42:48 EDT 1999 | Scott S. Snider
| After lots of years with Panasert machines, I am starting to need to learn again. | 1. For the AP-20 can you retrofit 3D vision? Would you bother? | 2. Also for the AP, can you use 20x20 DEK screens with an adapter? | | Thanks to all you MPM expe
Electronics Forum | Wed Aug 30 08:06:45 EDT 2006 | scombs
The reason I asked earlier about Gridlok is that we are using the on 2 Dek Horizon printers (since Jan 06) with edge clamps and they work well. We run them in Auto mode so they conform to the board at each print so I do not have to worry about the op
Electronics Forum | Wed Jul 23 05:16:43 EDT 2014 | edriansyah
Hi All... Need your advice on the unit of measurement for solder paste pressure. My current company use SP machine from 2 vendor, both are using different unit of measurement. 1. Yamaha uom N 2. DEK uom Kg Up until now I dont know how to do
Electronics Forum | Wed Nov 07 02:41:58 EST 2001 | marshall_shuai
Dear Mr. Jeff, Our SMT room are using the DEK288 and MPM2030 Printers at the same time. We found the similar problem also as mentioned by MR.JOHNW. We analysis it was mainly caused by the PCB metal fixture used in DEK288. The PCB metal fixture is
Electronics Forum | Thu Jul 25 20:47:13 EDT 2002 | Dreamsniper
Thanks for that info... I found out that MPM has UP2000 HiE VP with price lower than DEK Horizon but just a bit higher or let's say relatively the same as DEK ELA...I find it hard to decide which among the 2 based on our budget capability. My budget