Electronics Forum | Thu Feb 14 13:10:58 EST 2013 | markhoch
I had this problem once a loooooooong time ago with a 248 that was at my previous place of employment. If I remember correctly, my issue was caused by a set screw on the drive gear that had worked itself loose. My issue was stright forward and quickl
Electronics Forum | Tue Aug 19 14:24:22 EDT 2008 | shanenaturalpoint
My first problem is that when the unit homes, the print carriage seems to be traveling too far back. After the carriage reaches its mechanical limit, it continues to try and move back, eventually throwing up a print carriage error. Any ideas?
Electronics Forum | Thu Feb 04 15:57:13 EST 2021 | dilogic
We had the same problem and it was caused by faulty encoder, which we had to replace. - Dejan
Electronics Forum | Wed Nov 25 08:57:22 EST 2009 | dilogic
Is there anyone that wants to share real-life experience with DEK248 printer (with DekAlign, if possible)? Thanks in advance. - Deni
Electronics Forum | Tue Dec 09 08:51:56 EST 2008 | pjc
256 LT or Lite, low end fully auto machine, lower res alignment camera, not as accurate and repeatable as GSX. Wiper and Auto Paste dispensing optional. GSX is fully loaded with hi end camera alignment, auto paste, vac stencil wiper, may have auto fl
Electronics Forum | Tue Dec 03 07:57:27 EST 2002 | pjc
Price of DEK 248 and MPM UP100 are about the same, $22-36K range. MPM UP100 has programmable squeegee pressure. Precise, repeatable results with less operator involvement. Pressure parameters saved in board program file. DEK 248 has manual microm
Electronics Forum | Fri Jan 22 11:24:10 EST 2010 | thanh
HAVING A PROBLEM WITH DEK-248 REAR SQUEEGEES AFTER PRINT NOT COMING BACK UP. AFTER SHUT DOWN TO REBOOT, BOTH DROP DOWN,INITIALIZE MACHINE THE FRONT WORK NORMAL, THE REAR SLOWLY MOVING BACK UP, ANY ADVISE. THANKS
Electronics Forum | Sat Nov 06 06:41:11 EDT 2021 | ttheis
The DEK248 we had at one time was pretty compact but it did not have automated alignment- just a semi-manual camera/monitor stencil alignment process.
Electronics Forum | Mon Feb 21 18:13:23 EST 2005 | gpaelmo
As davef states above, you would like to have flat surfaces below 25 mil. We are a contract manufacturer also and we've done thousands of 15 mil QFP's with HASL finish with no problems. Your success will depend on quality of PCB supplier providing th
Electronics Forum | Tue Oct 11 13:35:30 EDT 2016 | mnorthey
When I had this problem on the DEK 248, the problem was the table up/down sensors on the motor. You can see if there is a problem in the maintenance mode in the inputs screen. They can be adjusted by loosening off the screws and moving the sensor un
winsouce.jpg)
