Electronics Forum | Thu Feb 14 13:10:58 EST 2013 | markhoch
I had this problem once a loooooooong time ago with a 248 that was at my previous place of employment. If I remember correctly, my issue was caused by a set screw on the drive gear that had worked itself loose. My issue was stright forward and quickl
Electronics Forum | Tue Aug 19 14:24:22 EDT 2008 | shanenaturalpoint
My first problem is that when the unit homes, the print carriage seems to be traveling too far back. After the carriage reaches its mechanical limit, it continues to try and move back, eventually throwing up a print carriage error. Any ideas?
Electronics Forum | Thu Feb 04 15:57:13 EST 2021 | dilogic
We had the same problem and it was caused by faulty encoder, which we had to replace. - Dejan
Electronics Forum | Fri Jan 22 11:24:10 EST 2010 | thanh
HAVING A PROBLEM WITH DEK-248 REAR SQUEEGEES AFTER PRINT NOT COMING BACK UP. AFTER SHUT DOWN TO REBOOT, BOTH DROP DOWN,INITIALIZE MACHINE THE FRONT WORK NORMAL, THE REAR SLOWLY MOVING BACK UP, ANY ADVISE. THANKS
Electronics Forum | Tue Oct 11 13:35:30 EDT 2016 | mnorthey
When I had this problem on the DEK 248, the problem was the table up/down sensors on the motor. You can see if there is a problem in the maintenance mode in the inputs screen. They can be adjusted by loosening off the screws and moving the sensor un
Electronics Forum | Wed Sep 04 12:02:03 EDT 2019 | spinn
Hi all, Just to add further information to this post. We have 10 inch (250mm)and 19 inch (480mm) Dek 248 complete printer squeegee clamps with blades. On the 250mm one blade has a very slight kink though shouldnt cause a problem. Offers welcome
Electronics Forum | Sun Dec 20 12:42:57 EST 2015 | dilogic
We have DEK248 and Ultraprint100 printers. Ultraprint100 has custom video hardware while DEK has PC-based vision,which I prefer. Both perform roughly the same, and each has some design advantages over the other. We do routinely print 0.5mm pitch TQF
Electronics Forum | Thu Feb 17 17:33:34 EST 2022 | mnorthey
Hi all, I have a Dek 265 Horizon that fails to print at the correct pressure. It fails pressure every pass. I am trying to Calibrate it with a PFR1200N pressure Tester which we use for our DEK 248 Printers. I am trying to build up the table height
Electronics Forum | Mon Feb 21 18:13:23 EST 2005 | gpaelmo
As davef states above, you would like to have flat surfaces below 25 mil. We are a contract manufacturer also and we've done thousands of 15 mil QFP's with HASL finish with no problems. Your success will depend on quality of PCB supplier providing th
Electronics Forum | Wed Sep 17 21:27:30 EDT 2008 | dekhead
I'll put a vote on MyData, but you might have problems with the volume... If you're buying used on this better off buying from MyData, they have a tendency to buy up the decent stuff off the used market, and anything left noone really wants to deal w
| 1 |
