Electronics Forum | Tue Mar 20 12:33:08 EDT 2018 | edjeske
how do i clear this error?
Electronics Forum | Tue Mar 20 18:28:26 EDT 2018 | dekhead
Print Head Stroke Calibration?
Electronics Forum | Wed Mar 21 19:35:38 EDT 2018 | dekhead
Not sure what blowing an airline would have to do with this; I sent you an email to get information on machine specifics for the procedures you need.
Electronics Forum | Wed Mar 21 14:58:23 EDT 2018 | edjeske
Thank you for your response. I appreciate all anyone can provide to help with this. I have no manuals to use. I inherited this task when the usual operator dropped dead the other day. He was the only one who ever ran this machine. I was able to print
Electronics Forum | Thu Feb 14 23:08:41 EST 2013 | dekhead
Squeegee error on a 248 is strictly that sensor (reed SW) on corresponding (Front / rear) squeegee cylinder is not seeing a change in state... Either a physical obstruction preventing cylinder from exending fully - OR- if it is extending fully, then
Electronics Forum | Wed Jun 19 11:26:06 EDT 2019 | key
We have been looking at the Sol for the in and out and the up and down for the blades. We moved the sol around with no change. where is the RS cylinder located in the DEK 248.
Electronics Forum | Thu Jun 13 20:03:05 EDT 2019 | dekhead
Does it cycle in/out in diagnostics? Have you checked pneumatics to to the RS cylinder?
Electronics Forum | Wed Jun 19 18:44:56 EDT 2019 | dekhead
Is the signal making it to the SOL? Is it toggling when signal is present? RS Cylinder is to the rear of the RS rails.
Electronics Forum | Thu Jun 20 10:23:47 EDT 2019 | key
Would you happen to have a picture of the RS Cylinder and Rs rail. When we send the table in sol 4 is on. When we try to send the table out sol 4 and 5 are on. We are having a hard time finding the RS Cylinder and RS rail
Electronics Forum | Thu Jul 18 13:15:25 EDT 2019 | dekhead
I guess you were able to locate the RS cylinder. Assuming adjustments to RS flow controls was your resolution.
winsouce.jpg)