Electronics Forum | Tue Mar 20 12:33:08 EDT 2018 | edjeske
how do i clear this error?
Electronics Forum | Tue Mar 20 18:28:26 EDT 2018 | dekhead
Print Head Stroke Calibration?
Electronics Forum | Wed Mar 21 19:35:38 EDT 2018 | dekhead
Not sure what blowing an airline would have to do with this; I sent you an email to get information on machine specifics for the procedures you need.
Electronics Forum | Wed Mar 21 14:58:23 EDT 2018 | edjeske
Thank you for your response. I appreciate all anyone can provide to help with this. I have no manuals to use. I inherited this task when the usual operator dropped dead the other day. He was the only one who ever ran this machine. I was able to print
Electronics Forum | Tue Jun 30 07:51:01 EDT 2009 | jen1724
I just purchased a used 2000 DEK 248 CE and I am looking for manuals, can anyone help me on this? Thanks
Electronics Forum | Thu Jul 26 19:00:34 EDT 2012 | aex
Weird question, but I need it for a claim. About how long does it take to assemble, plug in the power and dry cycle a DEK 248 with vision. I'm saying 90 minutes to two hours tops. Additional opinions would be greatly appreciated.
Electronics Forum | Mon Jun 23 15:28:41 EDT 2014 | globalpowerproducts
I have a 1997 DEK 248 screen printer that does not have the magnetic suction cups. Any thought on where i can find these or suggestions on how to secure the board on the table?
Electronics Forum | Mon Jun 23 21:28:33 EDT 2014 | dekhead
Not something that pops up on used market much; but still available from DEK. P/N: 002070 I think ~$200 for a set of 4 DEKHEAD www.dekhead.com
Electronics Forum | Thu Feb 14 10:23:32 EST 2013 | vincent_qms
Hello, we have a DEK 248 just acted up with the squeegee orror. unit powered up initiated and when throght setup a job fine but when we started printing, the back squeegee came down, touched the stencil, stay for about 5 second then came back up with
Electronics Forum | Thu Feb 14 23:08:41 EST 2013 | dekhead
Squeegee error on a 248 is strictly that sensor (reed SW) on corresponding (Front / rear) squeegee cylinder is not seeing a change in state... Either a physical obstruction preventing cylinder from exending fully - OR- if it is extending fully, then
.gif)
winsouce.jpg)