Electronics Forum | Tue Mar 20 18:28:26 EDT 2018 | dekhead
Print Head Stroke Calibration?
Electronics Forum | Wed Mar 21 14:58:23 EDT 2018 | edjeske
Thank you for your response. I appreciate all anyone can provide to help with this. I have no manuals to use. I inherited this task when the usual operator dropped dead the other day. He was the only one who ever ran this machine. I was able to print
Electronics Forum | Thu Feb 14 10:23:32 EST 2013 | vincent_qms
Hello, we have a DEK 248 just acted up with the squeegee orror. unit powered up initiated and when throght setup a job fine but when we started printing, the back squeegee came down, touched the stencil, stay for about 5 second then came back up with
Electronics Forum | Fri Feb 15 21:52:06 EST 2013 | nikyta
Most likely it is a faulty cable in the e-chain . You can test it in diagnostic: lower the back squeege and manually move back and forth for its entire travel the print carriage while monitoring the sensor output of the squeege. You will see at some
Electronics Forum | Mon Feb 20 17:12:54 EST 2006 | mark
Hallo all, I have recently had possibility to work with DEK265. I have met with problem poor print definition (no sharp edges). I used stencil 150 thickness, metal squuegees. I moved than the same stencil, squeegee and parameters to DEK nifinty and
Electronics Forum | Tue Aug 19 14:24:22 EDT 2008 | shanenaturalpoint
My first problem is that when the unit homes, the print carriage seems to be traveling too far back. After the carriage reaches its mechanical limit, it continues to try and move back, eventually throwing up a print carriage error. Any ideas?
Electronics Forum | Wed Aug 20 10:16:58 EDT 2008 | dekhead
248 Table In/Out is pneumatic (as stated), but I think Shane is referring to Print Carriage which is electrical with positional "encoder" feedback. Need to check for feedback display in output dignostic.
Electronics Forum | Tue Dec 03 07:57:27 EST 2002 | pjc
Price of DEK 248 and MPM UP100 are about the same, $22-36K range. MPM UP100 has programmable squeegee pressure. Precise, repeatable results with less operator involvement. Pressure parameters saved in board program file. DEK 248 has manual microm
Electronics Forum | Fri Jan 22 11:24:10 EST 2010 | thanh
HAVING A PROBLEM WITH DEK-248 REAR SQUEEGEES AFTER PRINT NOT COMING BACK UP. AFTER SHUT DOWN TO REBOOT, BOTH DROP DOWN,INITIALIZE MACHINE THE FRONT WORK NORMAL, THE REAR SLOWLY MOVING BACK UP, ANY ADVISE. THANKS
Electronics Forum | Tue Sep 05 17:38:27 EDT 2006 | flipit
I have a lot of experience on 1995 vintage Dek 248 and Dek 249. The 1995 to 1997 vintage were not the best. If Dek has improved them, great! If not, then I would not buy one. Dek 265 is a great printer. Dek did not put a lot of support into Dek
