Electronics Forum | Wed Dec 07 14:20:29 EST 2005 | Robert
I had a DEK 265LT with error code: motor comms failure.card 1, Axis123 fatal error-reinitialize machine during machine boost up I replaced new card 1 and still get the same error. Any suggestion would be greatly appreciated Thanks in advance, Rober
Electronics Forum | Fri Dec 09 02:26:31 EST 2005 | Alan.
Robert, power on the machine and go straight into DOS. You can do this by pressing and holding the Shift key as the machine is booting up. Run MINT. Try re-seating the cards too before you do this. Have you checked the voltages on the card batteries.
Electronics Forum | Mon Feb 02 13:46:33 EST 2004 | kauer
I'm back. By chance do You have another DEK You can swap cards with to help isolate the problem?
Electronics Forum | Mon Feb 02 15:09:09 EST 2004 | jsk
I don't have another dek to swap cards with and i'll keep you informed on the problem. It's running fine now but I don't think it will make it through the day. Thanks for the help.
Electronics Forum | Mon Feb 02 11:51:54 EST 2004 | jsk
error code: motor comms failure.card3, Axis123 fatal error-reinitialize machine I swapped x3 and x4, and still get the same error. Any suggestion would be greatly appreciated Thanks in advance, jsk
Electronics Forum | Wed May 19 14:44:53 EDT 2004 | JSK
Low voltage readings on (PSU 2). should be: = is: +12V = 4.3V -12V = 8.6V +24V = 7.6V Anysuggestions? (Other than buying a new card.) Thanks, jsk
Electronics Forum | Mon Nov 22 11:36:32 EST 2010 | mmjm_1099
I just has this issue and replaced the MIU card. I ordered it from IBE SMT. Make sure to troubleshoot before purchasing anything of course.
Electronics Forum | Fri May 12 13:33:27 EDT 2006 | mika
...Ehhhh?? Mark Fick, If the SMT Splice Clips or Kapton tapes does not solve Your DEK-265 motor comms failure problem, maybe try this: The 5 Volts should be within +/- 0.05 V. and if I remember correctly it must Not be under 4.5 V. We have been th
Electronics Forum | Mon Feb 02 12:46:36 EST 2004 | kauer
Just a hunch, pull out and re-seat the cards. also check power supply voltage. We bought 2 used machines and one of them would not boot up, the software would just go in a loop. Turns out the 5 volt power supply was low, 4.85v. just low enough to cre
Electronics Forum | Mon Feb 02 14:30:32 EST 2004 | kauer
Could be an intermitant card, or encoder issue. Sounds like the machine is giving this error because it is loosing track of one of the axis and instead of trying to move something and possibly crash, it locks up in error mode. Could be something as s
