Electronics Forum | Fri Jan 05 11:20:31 EST 2018 | dekhead
AC2 on MUX card).
Electronics Forum | Sun Sep 25 16:40:09 EDT 2011 | cbroegger
Have been through the same problem with the eurostep cards. The missing communications with the cards, suggest that some acid leaked from the batteries have etched tracks/and or the serial converters (soic8) on the cards. In all cases, clean the card
Electronics Forum | Thu Jul 30 22:48:17 EDT 2020 | dekhead
MM (MultiMove) cards are in the M19, Motor Control, crate (located front of machine, right side). MM's are the larger cards located on the far right side; X11, X12 and X13 slots (X11 slot is only used in Infinity, empty slot on Horizon / ELA).
Electronics Forum | Thu Mar 22 10:11:47 EDT 2012 | menatech
if you download the mint program (maintance key switched and download via auto mode. Does is read the card correct and does it identifies the correct motor encoder?
Electronics Forum | Wed Apr 11 19:53:28 EDT 2012 | dekhead
I believe the gentleman in India found a problem with one of the EuroSystem cards; AND then an issue with a corrupted PC MINT on the HDD... Seemingly resolved.
Electronics Forum | Thu Sep 22 18:47:08 EDT 2011 | rodrigo
Hi all, We just got this machine and it is not fully functional. I read somewhere here that the folder mint has some useful stuff. I run mint and it said that it cannot communicate with card 0,1,2,3 (x1,x2,x3,x4). It said to make sure the cards are
Electronics Forum | Thu Mar 28 08:12:19 EDT 2019 | carehawk
We had an issue where a vision cable got cut and a few wires were exposed and possibly shorted. We fixed the cable and since then have had numerous errors with the last one being pneumatic power down. We have air to the machine and have checked the p
Electronics Forum | Fri Jan 05 10:58:43 EST 2018 | ilavu
John, I just found out more detail. If my board stop position in x is bigger than 109mm, I get error from park position to board stop.This problem started after power loss. The error comes up system power down and after pressing system button "RISIN
Electronics Forum | Wed Aug 24 05:23:45 EDT 2016 | bukas
hello, DEK wont start and im getting this error message: motor com error, axis 1,2,3 fatal error, reinitialise machine. this happens about 30 sec after BIOSes are copied to shadow ram. euro sys cards are inserted properly and on segment display is s
Electronics Forum | Wed Aug 31 08:12:37 EDT 2016 | ttheis
Search for the bios or motherboard on ebay. Type in the part numbers you find on the boards and see if anything comes up. Often these are standard pc boards. I've repaired my old MPM by finding the cards on ebay cheap.