Electronics Forum | Fri Feb 19 09:34:27 EST 2010 | baildl632
Thanks for the support. Maybe you can help me with another problem. I get a pate dispensor error command time out, which clears itself, then a screen actuator error command time out that doesn't clear during initialisation. Machine won't do anything
Electronics Forum | Wed Jun 03 06:45:38 EDT 2009 | aj
machine wont initialise after breaker tripped when machine was powered down over the weekend. All PSU's check out fine along with Estop circuit. I get the command to press system button but thats as far as it goes. any ideas welcomed
Electronics Forum | Mon Feb 26 12:10:24 EST 2007 | JCB
As you are running Left to Right it is the trailing edge of the board leaving the board at left opto that tells the board stop to lower (not the sensor under the camera - that just confirms the board has arrived at the board stop). How big is the boa
Electronics Forum | Tue May 04 11:30:19 EDT 2010 | tsventek
I just had the same issue, it was a corrupt fiducial file in the program that kept on loading when booted. If your vision card is working follow these steps: Reboot the machine, press F5 when the computer beeps to enter DOS, delete the file maninf.d
1 |