Electronics Forum | Thu Feb 04 13:21:08 EST 2010 | baildl632
I'm during this rught now and windows will not recognize the hard drive as a hard drive. It recognizes a mass storage device and that's about it. No way to copy, move or do anything o anything on the drive. Have you got any suggestions as to why?
Electronics Forum | Thu Jan 07 09:58:14 EST 2010 | kjs123p
Pull the hard drive out and use a USB to IDE adapter to copy the whole hard drive onto another computer. I do this with my reflow oven and screen printer. It works very well.
Electronics Forum | Wed Jan 06 15:25:35 EST 2010 | wolverine
Any help would be appreciated We have a DEK 265 Screener that has been showing symtoms of a bad power supply. Is there a way to back up the hard drive and is an executive program needed in case the machine totally dies. Dave
Electronics Forum | Fri Feb 05 11:56:58 EST 2010 | kjs123p
It should show up as a mass storage device. Not to insult you intelligence, but do you have the hard drive powered up? You need to power it up if you haven't done that.
Electronics Forum | Fri Feb 05 12:25:37 EST 2010 | baildl632
Yes, it's powered up. We use a simple power supply that connects directly to the drive. It spins up fine. I belive my problem is with Windows not recognizing the old type of drive correctly. It does recognize it as a mass storage device (the drivers
Electronics Forum | Thu Oct 26 12:14:34 EDT 2017 | lefwan
Our DEK 265 machine is showing this error message during starting…than it keeps re-starting in endless loops: Diskette drive failure on drive A Fixed Disk Controller Failure Fast ready check - Version 1.0 Copyright Arcom Control Systems Ltd. CMOS
Electronics Forum | Fri Oct 27 10:43:08 EDT 2017 | sumote
i believe someone has left a floppy disk in the drive. eject it and reboot.
Electronics Forum | Mon Mar 01 22:51:05 EST 2021 | rob1
We have a DEK 265 Horizon and it exhibits a problem with conveyor belts. When I power up the DEK and try to paste boards, it fails to initialize the conveyor. I have to go into Maintenance and select cycle boards on rails. This too fails, but when I
Electronics Forum | Tue Mar 02 02:52:09 EST 2021 | dekhead
I assume you are saying that the rail width doesn't initialise when you initialise machine, but when you go into diagnostics and then exit diagnostics it initialises properly. (Not sure what cycling board on belts has to do with it). Have seen, on mu
Electronics Forum | Fri Aug 24 02:40:52 EDT 2018 | bukas
first check fuses in Y1 case. thats where EuroSYS cards are, and message you get tells you that cards can not communicate with main processing board in Y3 case via RS485. after that check cables and connectors. there are 4 EuroSYS cards in Y1 case, t
