Electronics Forum | Mon Jan 20 17:37:30 EST 2020 | sumote
Here is a picture of the inside of my machine. https://drive.google.com/file/d/1hsLLHz1ho867qcSf7AYUoivUUn8NFbH6/view?usp=sharing
Electronics Forum | Wed Dec 13 08:54:28 EST 2017 | raymccomb
We have a DEK 265 and we have fitted new belts to it after one split in use. when we set back up and run program A all is OK, when we go to run program B it has System Error. Servo Following Error - Fatal Error - Reinitialise machine. Does any one h
Electronics Forum | Tue Nov 10 21:00:41 EST 2020 | mikewschomisch
I removed the ribbon cable from the FDD and edited the setting in SETUP to "NOT Installed";. Came back with 'Diskette drive failure on drive A'. on reboot. Still shows "Diskette error" on last line. Possible HDD issue? Thanks.
Electronics Forum | Wed Aug 31 07:40:58 EDT 2016 | bukas
BIOS stopped loading, now when I start machine monitor doesn't receive any signal. tried to start machine with different hard drive but nothing
Electronics Forum | Thu Oct 29 13:55:57 EDT 2015 | edgeflex
Hi, Since we change the small best of the head carriage, the head is not going to the right positions (paste/front/rear). I could not even make a pressure test. Anyway I don't have any error message. Does somebody knows something about this and ho
Electronics Forum | Sun Jul 18 12:13:06 EDT 2021 | oriolsancheza
Hello, Our machine started to not stopping board into the right position (stop pin was not working we guess). After some inspection we have not seen anything strange. However the DEK software decided to not work anymore. We've been messing arrounf
Electronics Forum | Mon Jul 13 20:24:10 EDT 2020 | emanuel
Can't find the correct part number for the conveyor belt of a DEK Europa. It is round and green, perhaps antistatic type. I found the part number of the same for 265GSX, it is 122022 G4957. Any idea if the Europa uses the same belt size as the 265GSX
Electronics Forum | Fri Jun 04 02:51:25 EDT 2010 | tomta
We have a DEK 265 printer currently down due to the rail system error. The message "Belt Motor Error. Rail lifted error, check tooling" pop-up when pressed run. I did remove all the support pins prior loading a new job. I also ran rail system dian
Electronics Forum | Thu Feb 22 22:57:59 EST 2007 | dekhead
What software version is running? Assumption it is running with FMI, what is UL protocol? Change UL protocol to "Manual", belt should not start running until board is placed over sensor, confirm! All products or just 1? What is board width of curr
Electronics Forum | Tue Feb 18 06:29:04 EST 2020 | leeg
We are having a few issues lately with a Data file open error on the printer and also the belts carrying on spinning when the PCB has hit the board stop even though the board stop sensor is activated that it has seen the PCB, anyone seen these issues
