Electronics Forum | Wed Jun 26 13:42:14 EDT 2013 | nucleus
Hi, we just bought a used dek infinity 265. Unfortunately we cannot find a programming manual. We have two big technical references and a operator manual. Is there someone who has a pdf-version of the programming manual? Thanks! Best regards mts
Electronics Forum | Wed Jun 26 17:46:48 EDT 2013 | dman97
numeric values are input by pressing the / key.
Electronics Forum | Fri Mar 13 17:43:16 EDT 2015 | loganting
how helpful is it to use alignment weighting over fiducial offsets ?
Electronics Forum | Wed Jun 26 13:44:37 EDT 2013 | nucleus
by the way: How can I input numeric values by keyboard instead of pressing value +/- all the time? thanks!
Electronics Forum | Fri Mar 13 17:11:23 EDT 2015 | loganting
2 fiducial alignment vs 3 fiducial alignment , any opinion ? When do we actually need the third fiducial for alignment ?
Electronics Forum | Fri May 29 06:50:04 EDT 2015 | buckcho
Hello, can you explain better what do you want to check? Alignment is done based on fiducial check and then you can do some offsets, based on the print. So I am not sure what do you want to say...
Electronics Forum | Fri May 29 14:19:14 EDT 2015 | dekhead
Offsets are there to for an alignment change over the entire board... alignment weighting is, essentially to account for imperfect match between stencil and board, and will allow you to concentrate best alignment to a given portion of the board (give
Electronics Forum | Tue Nov 20 18:56:19 EST 2018 | dekhead
If always on... you will need to write product file as edge justified, and position stencil properly before auto-clamping takes place. If always off... you will need to write product file as center justified... and position stencil and acknowledge st
Electronics Forum | Wed Nov 21 09:10:11 EST 2018 | dekhead
Are you seeing the stencil operational (changing state) in diagnostics? If sensor works then, look at image justification in product file...
