Electronics Forum | Thu Feb 21 13:50:26 EST 2019 | s197seth
I am trying to do a Pass Through and the DEK wont send the board to the Conveyor and it says its waiting for downline transfer even when the SMEMAs are tripped. and on the Multi - Interface Unit, the light next to downline ready is not on. Any help?
Electronics Forum | Thu Feb 13 10:38:33 EST 2003 | vortex
While trying to develop new programs for our DEK Horizon 265 we are forced to use pads as vision alignments due to lack of real fiducals, thanks engineering. My question is, Is there any way to narrow the search window when performing a locate fiduca
Electronics Forum | Mon Feb 24 12:14:07 EST 2003 | gilligan
We use an EKRA E4 printer, but the concept sounds the same as far as the fiducial alignment goes. I have found that SOT-23 components work the best for fiducials - and I always make it a point to use them on our older PCB's (where the screens do not
Electronics Forum | Tue Mar 02 02:52:09 EST 2021 | dekhead
I assume you are saying that the rail width doesn't initialise when you initialise machine, but when you go into diagnostics and then exit diagnostics it initialises properly. (Not sure what cycling board on belts has to do with it). Have seen, on mu
Electronics Forum | Tue Mar 02 12:50:12 EST 2021 | ttheis
I have a parts 265 horizon if you want it. Was told it needs a front rail sensor but lmk if you are interested. Will sell cheap, located in milwaukee area.
Electronics Forum | Tue Mar 29 14:43:50 EDT 2022 | padawanlinuxero
Hi! Looks likely you have a calibration problem with the vision system, since is a 265 if possible try to restore a backup on floppy if not rerun the calibration procedure
Electronics Forum | Sat Mar 05 14:41:52 EST 2005 | Velocidog
Anyone have any they aren't using anymore or know where I can buy some second-hand or aftermarket? Thanks
Electronics Forum | Fri Mar 11 09:38:26 EST 2005 | cbarnett
I would suggest that you make pins in house, we are currently making pins & blocks for board support.
Electronics Forum | Sun Dec 23 00:11:43 EST 2007 | ktroym
When I try to bootup the machine I am getting an error that reads Dumping physical memory and a bunch of numbers & letters on the screen. The machine runs windows NT. Has anyone else had a problem like this before.
Electronics Forum | Sun Jan 06 22:08:09 EST 2008 | mac88
Hi, Try to upload the Windows NT in Safe Mode. Would look weird, but is fully functional. Then try to go the latest known workable configuration and load it. If this does not work try with the recovery disk that came with the machine. This will
