Electronics Forum | Fri Jun 04 02:51:25 EDT 2010 | tomta
We have a DEK 265 printer currently down due to the rail system error. The message "Belt Motor Error. Rail lifted error, check tooling" pop-up when pressed run. I did remove all the support pins prior loading a new job. I also ran rail system dian
Electronics Forum | Mon May 03 08:42:12 EDT 2010 | dekhead
The $20K number thrown out there by the OEM would lead me to believe there is something else going on and/or it's the black camera vision... green/silver they usually use the $10K. DEKHEAD
Electronics Forum | Wed May 05 04:25:42 EDT 2010 | vms
We sale the cognex cards for 3500.00 all of the time, think we need to raise our prices. Right bruce? Harry
Electronics Forum | Fri Jun 04 09:31:48 EDT 2010 | thanh
there are 2 rail lift sensors at left and right of the table, maybe need to clean or re-adjust.
Electronics Forum | Mon Sep 20 12:24:18 EDT 2010 | remullis
Can you remove the interlock mechanism that makes the switch from the hood insert into the switch and trick the machine then close the hood palm down and put everything back? Some machines use magnets, some use the slotted switch with a metal key t
Electronics Forum | Mon Sep 20 13:37:09 EDT 2010 | kjs123p
Did you make sure you don't have any E-stops on?
Electronics Forum | Mon Sep 20 14:11:39 EDT 2010 | dman97
Yes I have checked both covers and they are both closed. The latch keys are sitting in their respective slots. I need to know how I can lower the hood manually or if there is a way to get into the diagnostics menu before the machine boots. Thanks.
Electronics Forum | Mon Sep 20 18:29:40 EDT 2010 | ratsalad
2 minutes before I posted! So, what did you end up doing to get it back up and running? Thanks
Electronics Forum | Tue Sep 21 17:47:27 EDT 2010 | dman97
Yes, Sorry I meant the Y3 enclosure. Anyway Thanks to DEKHEAD and jamyboy for helping me out on this problem. You guys are great. Thanks again.
Electronics Forum | Tue May 04 11:30:19 EDT 2010 | tsventek
I just had the same issue, it was a corrupt fiducial file in the program that kept on loading when booted. If your vision card is working follow these steps: Reboot the machine, press F5 when the computer beeps to enter DOS, delete the file maninf.d