Electronics Forum | Thu Mar 22 10:11:47 EDT 2012 | menatech
if you download the mint program (maintance key switched and download via auto mode. Does is read the card correct and does it identifies the correct motor encoder?
Electronics Forum | Wed Apr 11 11:26:30 EDT 2012 | aj
I would recommend that you disconnect the colour monitor and replace it with a standard one.... these monitors are dodgy as hell and cause untold problems throughout the power circuitry...try it and see how you get on...
Electronics Forum | Wed Apr 11 19:53:28 EDT 2012 | dekhead
I believe the gentleman in India found a problem with one of the EuroSystem cards; AND then an issue with a corrupted PC MINT on the HDD... Seemingly resolved.
Electronics Forum | Fri Sep 28 10:04:14 EDT 2012 | dwelch123
Looking for some help. I'm getting no power to the main machine. All power supplies are getting correct power in but not outputing power. All output terminals on power supplies read 0V. The main transformer outputs all check with proper voltages. At
Electronics Forum | Fri Sep 28 21:30:35 EDT 2012 | dekhead
Assuming you are not seeing 240VAC @ PSU inputs. Present @ transformer, but not much beyond CB1 on Y4... Nothing to PSU's or PC, etc. Inrush suppressor(s) (Thermistors). Contact me directly. www.dekhead.com
Electronics Forum | Sat Mar 30 13:33:50 EDT 2019 | stephendo
This is not an HVAC unit. This is a small unit attached to a production machine to keep the solder paste from drying out prematurely or slumping. The volume of air being cooled and desicated would be less than 3 or 4 cubic meters.
Electronics Forum | Sat Aug 13 22:55:11 EDT 2022 | dekhead
Most likely an issue with vision system, or communication therewith... But with # of combinations of CPU, Cognex and cameras, would prefer off forum contact to sort it out. email sent.
Electronics Forum | Tue Aug 16 06:20:34 EDT 2022 | bukas
it can be a bad contact with backboard. clean the slot and gold fingers with contact cleaner and push it in and out a few times.
Electronics Forum | Tue Mar 20 05:03:47 EDT 2012 | sunyb123
Dear sir, i have face same problem of motor Communication fail Card0,Card1,I Clean Whole card properly, change the battery new one ,reprogrammed mint, but Card 2&Card3 loaded the mint programmed but not in card 0 & card 1, Please suggest what to d
Electronics Forum | Thu Jul 16 12:50:36 EDT 1998 | smd
200 boards an hour and probably does. Our slow P&P machine keeps us from getting that benefit. But we get to have all the headaches. I think the printer runs on a 286! That's pretty sorry for such an expensive piece of equipment. The stencil frame is
.jpg)